Integrated Dishwasher Installation Guide

General Dimensions and Requirements

This section outlines the necessary dimensions for installing the integrated dishwasher. Ensure the cabinet space meets the specified requirements.

Cabinet Dimensions:

• Minimum internal width: 600 mm (for 60 cm models)
• Minimum internal width: 450 mm (for 45 cm models)
• Minimum internal height: 820 mm
• Maximum internal height: 860 mm
• Minimum depth: 560 mm
• Minimum clearance from front edge: 600/450 mm

Appliance Dimensions:

• 60 cm models: 598 mm width, 815 mm height, 550 mm depth
• 45 cm models: 448 mm width, 815 mm height, 550 mm depth

Weight Requirements:

• Top of the appliance can support 2-10 kg.
• The appliance itself weighs between 2-7.5 kg.

Included Accessories:

The installation kit includes various tools and components:

• Gloves (a)
• Screwdrivers (b, c)
• Spirit level (d)
• Pliers (e)
• Adjustable wrench (f)
• Screws: 4x Ø4x25 mm (g), 2x Ø3.5x16 mm (h), 2x Ø3.5x16 mm (i)
• Nuts: 4x Ø4x38 mm (j)

Technical Specifications:

Noise level for both 60 cm and 45 cm models is 41/42 dB.

• 60 cm model: Required recess depth (k) is 585 mm.
• 45 cm model: Required recess depth (k) is 435 mm.

Refer to measurements 598/435 mm and 594/444 mm for specific fitting details.

Installation Steps

Follow these steps carefully for a proper installation:

Step A: Preparing the Cabinet

Ensure the cabinet is ready and clear for the dishwasher. Diagrams show how to position and secure side panels.

Step B: Attaching Brackets

Attach the necessary brackets to the appliance and the cabinet using the provided screws (g, h, i, j).

Step C: Inserting the Dishwasher

Carefully slide the dishwasher into the prepared cabinet space. Ensure it is level.

Step D: Securing the Dishwasher

Secure the dishwasher to the cabinet using the provided screws. Adjust leveling feet as needed.

Step 1-5: Detailed Mounting Procedures

Detailed diagrams illustrate the process of attaching the front panel, securing the appliance, and making initial adjustments. Pay attention to the specific screw types and their placement.

Step 6: Sliding into Place

Slide the dishwasher into the cabinet opening.

Step 7: Checking Dimensions

Verify that the dishwasher fits within the specified dimensions after insertion.

Step 8: Connecting Water and Drainage

Connect the water inlet hose and the drain hose according to the diagrams. Ensure secure connections to prevent leaks.

• Water inlet pressure: min 0.05 MPa / 0.5 Bar, max 1 MPa / 10 Bar.
• Drainage hose length: min 400 mm, max 800 mm.
• Ensure the drain hose is correctly positioned to avoid siphoning.
• The water connection should be made to a cold water supply.

Step 9: Electrical Connection

Connect the dishwasher to the electrical supply. Ensure the power outlet is properly grounded.

Step 10: Final Checks

Perform final checks on all connections (water, drainage, electrical) and ensure the appliance is stable and level. Check that all warning symbols (X) are addressed and all check symbols (✔️) are met.

Ensure the water inlet hose is connected to a tap with a minimum diameter of 25 mm.

The distances for the drain hose are indicated as approximately 1300 mm, 1500 mm, and 1500 mm.