Kingston Brass Lift & Lock Drain Installation Instructions

Tools Required

• Drain Wrench
• Dumbbell Drain Wrench
• Teflon Tape
• Pipe Wrench
• Screwdriver
• Plumbers putty

Installation Step:

1. Using either a 4 way or a dumbbell wrench remove old drain and clean area around the drain opening.
2. Remove drain stopper by unthreading counterclockwise.
3. Apply plumbers putty under the drain flange or insert rubber gasket, apply Teflon tape on threads.
4. Carefully thread drain by hand, finish tightening using the 4 way wrench or the dumbbell wrench.
5. Clean any excess plumber putty and re-install the drain stopper.

Diagram Description

The diagram illustrates the components of the Lift & Lock Drain. It shows a 'Stopper' at the top, which fits into the 'Drain Body'. Below the drain body is a 'Rubber Washer'.