Quick Start Guide - Type1SC Evaluation Kit
by Murata INNOVATOR IN ELECTRONICS
You can use this EVK for Type1SC communication test and power evaluation. A complete Type1WG/Type1SC EVK User Guide can be found in our my Murata Type1SC/Type1WG Support Site. If you have any questions about the support site registration process, please contact our local sales via www.murata.com/en-global/support/contactinformation.
About Type1SC
- Module Size: 11.4 x 11.1 x 1.5mm
- Connectivity: Cat-M1/NB-IoT
- Interface: UART/SPI/GPIO
- Support GNSS, VoLTE
- 16 MB of flash
What Murata Supply
- Type1SC EVK
- Quick Start Guide
- Support Site Access Guide
What Customer Need
- Windows® OS (XP, 7, 8, 10)
- COM port driver: (CP210xVCPInstaller_x64.exe)
https://www.silabs.com/documents/public/software/CP210x_VCP_Windows.zip - Command tool (Tera Term):
https://osdn.net/projects/ttssh2/releases - Type Mini USB Cable
- SIM card
How to connect
Connect the Type1SC EVK to your PC and the antenna or tester.
Connection Diagram
Figure 1: EVK appearance
The evaluation kit board features connection points for a PC via AT CMD & Power Supply, and for an antenna or tester via an SMA Connector. Key components labeled include the 'Type 1SC' module, a 'Reset' button, and an 'On Board Antenna'. A Micro SIM slot is also visible.
How to use
- Connect the Type1SC EVK to PC (Refer to Figure 1).
- Setup Tera Term (Refer to Figure 2).
- Confirm the log from Tera Term (Refer to Figure 3). Input "at" and you should see "OK" as a response.
- You can use AT commands to control Type1SC.
Tera Term Setup
Figure 2: Tera Term Configuration Window
This window guides the user through configuring Tera Term for serial communication. It allows selection of the COM port (e.g., USB Serial Port), setting the baud rate to 115200, and configuring data bits, parity, stop bits, and flow control.
Command Confirmation
Figure 3: Tera Term Command Window
This terminal window shows the interaction with the Type1SC module. After connecting, typing the command "AT" results in the response "OK", indicating successful communication and that the module is ready to accept commands.
For detailed AT command information, please refer to the Murata Type1SC/Type1WG Support Site.
