Regulatory Compliance
Router / Omada Hardware Controller
FCC Compliance Information Statement - Class A Product with Power Adapter
This section applies to the following Router models:
- TL-R600VPN
- TL-R470T+
- ER7212PC
- ER707-M2
Responsible party: TP-Link USA Corporation
Address: 10 Mauchly, Irvine, CA 92618
Website: https://www.tp-link.com/us/
Tel: +1 626 333 0234
Fax: +1 909 527 6804
E-mail: sales.usa@tp-link.com
[FCC Logo]
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- 1) This device may not cause harmful interference.
- 2) This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Power Adapter Models:
| Component Name | Model |
|---|---|
| Power Adapter | T090060-2B1 (For TL-R600VPN / TL-R470T+) |
| Power Adapter | T535243-2-DT (For ER7212PC) |
| Power Adapter | T120150-2B1 (For ER707-M2) |
FCC Compliance Information Statement - Class B Product with Power Adapter
This section applies to the following Router models:
- ER605 V1 (TL-R605)
- ER605 V2
- ER7206 V2
Responsible party: TP-Link USA Corporation
Address: 10 Mauchly, Irvine, CA 92618
Website: https://www.tp-link.com/us/
Tel: +1 626 333 0234
Fax: +1 909 527 6804
E-mail: sales.usa@tp-link.com
[FCC Logo]
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- 1) This device may not cause harmful interference.
- 2) This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Power Adapter Models:
| Component Name | Model |
|---|---|
| Power Adapter | T090085-2B1 (For ER605 V1) |
| Power Adapter | T120100-2B1 (For ER605 V2 / ER7206 V2) |
FCC Compliance Information Statement - Class A Product with No Power Adapter
This section applies to the following Router and Omada Hardware Controller models:
- Routers: TL-R480T+, ER7206 V1 (TL-ER7206), ER8411
- Omada Hardware Controller: OC300
Responsible party: TP-Link USA Corporation
Address: 10 Mauchly, Irvine, CA 92618
Website: https://www.tp-link.com/us/
Tel: +1 626 333 0234
Fax: +1 909 527 6804
E-mail: sales.usa@tp-link.com
[FCC Logo]
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- 1) This device may not cause harmful interference.
- 2) This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
We, TP-Link USA Corporation, has determined that the equipment shown as above has been shown to comply with the applicable technical standards, FCC part 15. There is no unauthorized change is made in the equipment and the equipment is properly maintained and operated.
Issue Date: 2023/2/2
FCC Compliance Information Statement - Class B Product with No Power Adapter
This section applies to the following Omada Hardware Controller models:
- OC200
Responsible party: TP-Link USA Corporation
Address: 10 Mauchly, Irvine, CA 92618
Website: https://www.tp-link.com/us/
Tel: +1 626 333 0234
Fax: +1 909 527 6804
E-mail: sales.usa@tp-link.com
[FCC Logo]
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- 1) This device may not cause harmful interference.
- 2) This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
We, TP-Link USA Corporation, has determined that the equipment shown as above has been shown to comply with the applicable technical standards, FCC part 15. There is no unauthorized change is made in the equipment and the equipment is properly maintained and operated.
Issue Date: 2023/2/2
Regional Declarations and Certifications
CE Mark Warning & EU Declaration of Conformity
[CE Logo]
This is a class A product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.
TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/30/EU, 2014/35/EU, 2011/65/EU and (EU)2015/863. (Note: Some pages mention 2009/125/EC, which is also included here for completeness if applicable across models).
The original EU declaration of conformity may be found at https://www.tp-link.com/en/support/ce/
UKCA Mark & UK Declaration of Conformity
[UKCA Logo]
TP-Link hereby declares that the device is in compliance with the essential requirements and other relevant provisions of the Electromagnetic Compatibility Regulations 2016 and Electrical Equipment (Safety) Regulations 2016.
The original UK declaration of conformity may be found at https://www.tp-link.com/support/ukca/
Canadian Compliance Statement & Industry Canada Statement
English:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:
- (1) This device may not cause interference.
- (2) This device must accept any interference, including interference that may cause undesired operation of the device.
French:
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
- 1) L'appareil ne doit pas produire de brouillage;
- 2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Industry Canada Statement: CAN ICES-3 (A)/NMB-3(A) [VCCI-A]
BSMI Notice, Restricted Substances List & EAC Declaration
BSMI Notice (Chinese):
- 請使用原裝電源供應器或只能按照本產品注明的電源類型使用本產品。 (Use the original power adapter or only use the power type specified for this product.)
- 清潔本產品之前請先拔掉電源線。請勿使用液體、噴霧清潔劑或濕布進行清潔。 (Please unplug the power cord before cleaning the product. Do not use liquid, spray cleaners, or damp cloths for cleaning.)
- 注意防潮,請勿將水或其他液體潑灑到本產品上。 (Beware of moisture, do not spill water or other liquids onto the product.)
- 插槽與開口供通風使用,以確保本產品的操作可靠並防止過熱,請勿堵塞或覆蓋開口。 (Slots and openings are for ventilation to ensure reliable operation of the product and prevent overheating, do not block or cover the openings.)
- 請勿將本產品置放於靠近熱源的地方。除非有正常的通風,否則不可放在密閉位置中。 (Do not place the product near heat sources. Unless there is normal ventilation, do not place it in a confined space.)
- 不要私自拆開機殼或自行維修,如產品有故障請與原廠或代理商聯繫。 (Do not disassemble or repair the product yourself. If the product is faulty, please contact the manufacturer or agent.)
Restricted Substances List (Chinese Table):
| 單元 (Unit) | 鉛 (Pb) | 汞 (Hg) | 鎘 (Cd) | 六價鉻 (Cr+6) | 多溴聯苯 (PBB) | 多溴二苯醚 (PBDE) |
|---|---|---|---|---|---|---|
| PCB | ○ | ○ | ○ | ○ | ○ | ○ |
| 外殼 (Enclosure) | ○ | ○ | ○ | ○ | ○ | ○ |
| 電源供應器 (Power Supply) | — | ○ | ○ | ○ | ○ | ○ |
備考1. "超出0.1 wt %" 及 "超出0.01 wt %" 係指限用物質之百分比含量超出百分比含量基準值。
備考2."○"係指該項限用物質之百分比含量未超出百分比含量基準值。
備考3."—" 係指該項限用物質為排除項目。
EAC Declaration (Ukrainian): Продукт сертифіковано згідно с правилами системи УкрСЕПРО на відповідність вимогам нормативних документів та вимогам, що передбачені чинними законодавчими актами України. ([EAC Logo])
Safety Information
- Keep the device away from water, fire, humidity or hot environments.
- Do not attempt to disassemble, repair, or modify the device. If you need service, please contact us.
- Do not use damaged charger or USB cable to charge the device.
- Do not use any other chargers than those recommended.
- Adapter shall be installed near the equipment and shall be easily accessible.
- Place the device with its bottom surface downward.
- Use only power supplies which are provided by manufacturer and in the original packing of this product. If you have any questions, please don't hesitate to contact us.
- The plug on the power supply cord is used as the disconnect device, the socket-outlet shall be easily accessible.
- The operating temperature for the device shall be within 0°C to 40°C (32°F to 104°F).
Please read and follow the above safety information when operating the device. We cannot guarantee that no accidents or damage will occur due to improper use of the device. Please use this product with care and operate at your own risk.
*Note: Specific cautions may apply to certain models, e.g., "This caution applies to ER8411."
Explanation of the Product Label Symbols
Note: The product label can be found at the bottom of the product and its I.T.E. power supply.
| Symbol | Explanation |
|---|---|
[Class II Equipment Symbol] |
Class II equipment |
| Alternating current [AC Symbol] | |
| Direct current [DC Symbol] | |
| For indoor use only [Indoor Use Symbol] | |
| Polarity of d.c. power connector [DC Polarity Symbol] | |
VI |
Energy efficiency Marking [Energy Efficiency Symbol] |
| RECYCLING [Recycling Symbol] This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment. User has the choice to give his product to a competent recycling organization or to the retailer when he buys a new electrical or electronic equipment. | |
| Frame or chassis [Frame/Chassis Symbol] | |
| Functional earthing [Functional Earthing Symbol] | |
| Caution [Caution Symbol] | |
| Operator's manual [Operator's Manual Symbol] | |
| Caution, risk of electric shock [Shock Hazard Symbol] | |
| Disconnection, all power plugs [Power Disconnect Symbol] |
