Funsicle QuickSet Pool Quick Start Guide
Sign up for future offers and discounts. Scan the QR Code.
Ready. Set. Play.
This Quick Start Guide provides a simple overview to your pool's setup process.
For detailed setup guidelines, important safety information and useful tips, refer to the enclosed “Funsicle QuickSet Pool User Guide.”
STEP ONE: Prepare the site.
Locate a clean and flat level area free of stones or sharp objects.
TIP: Let the liner sit under the sun for at least two hours prior to installation; this allows the liner material to be more flexible and ensure a wrinkle-free fit.
Image description: A person is carefully unfolding a large blue pool liner on a flat, grassy surface.
STEP TWO: Lay out the liner.
STEP THREE: Inflate the top ring.
- Inflate the air chambers following the numbered sequence (if any) slowly with a manual/foot air pump. Use cold air only.
- Check to confirm adequate air pressure. Your pool should be firm to the touch but not hard. Do not overinflate. Refer to the enclosed User Guide for more information about air pressure.
- Close and press the inflation valves into the unit to get a flat surface.
Image description: A person is using a foot-operated air pump to inflate the top ring of the pool.
Image description: A close-up view of the pool's inflation valve being pressed into the surface to create a flat seal.
STEP FOUR: Add 1 inch of water to the pool and then install filtration system.
- After ensuring that the drain fitting is plugged securely and the cap is in place, fill the pool with about an inch of water. Then stop filling, and smooth out all wrinkles in the liner.
- Install the filtration system as per the enclosed “Funsicle Cartridge Filter Pump User Guide.”
- Continue adding water to your pool and refer to the “Funsicle QuickSet Pool User Guide” for information and best practices about using, maintaining, draining, storing and/or winterizing your pool.
Image description: A hand is shown securing the drain fitting inside the pool liner as a small amount of water begins to fill it.
Image description: Feet are stepping on the pool liner to smooth out any wrinkles after adding the initial inch of water.
Image description: The Funsicle cartridge filter pump system is being connected to the pool's water outlet.
Image description: The Funsicle QuickSet Pool is shown fully set up and filled with water, with a yellow inflatable ring floating inside.
Funsicle Customer Service
Website: funsicle.com/support
Phone: 888-670-4FUN (888-670-4386)
Email: HelloFun@Funsicle.com
