Instruction Manual for sincere models including: Y1, Y1 Handheld Audio Microphone, Handheld Audio Microphone, Audio Microphone, Microphone
Shenzhenshixinyihekejimaoyi Co., Ltd. Y1 Wireless Speaker 2BF2H-Y1 2BF2HY1 y1
Y1 handheld audio microphone Operation manual 1. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 2. --Reorient or relocate the receiving antenna 3. --Increase the separation between the equipment and receiver. 4. --Connect the equipment into an outlet on a circuit different from that to which the 5. receiver is connected. 6. --Consult the dealer or an experienced radio/TV technician for help. 7. Important: Change or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment. Function introduction 8. short press once to decrease the volume and long press the previous song 9. Manually switch playback mode,BT/TF card U disk,etc. 10. short press the volume once,and long press one song 11. Shot press toggle LED lighting effect,long press for 2 seconds to turn off LED lighting effect, 12. Long press for three seconds to power on/off,short press play/pause , Double - click to turn on/off couplets. 13. Short press to tum on/of the original sound. 14. on and on,and short press once to mute the microphone.on and on,and short press once to mute the microphone. 15. Shot press Microphone Volume Plus,double-dick Reverb Plus. 16. Short press the microphone volume down,double click the reverb to decrease. 17. Short press to cancel the original sound on/off,long press to switch the magic sound. 18. Microphone indicator,blue light flashing in unconnected state,blue light is always on when connected successfully.red light is on when charging.and red light is off after full charge. 19. Microphone Type-C 5V charging port 20. Headphone jack 21. TF card slot,insert files with MP3 audio class automatically switch to TF mode. 22. Audio Type-C 5V charging interface. 23. USB socket insert files with P3 audio class automatically switch to USB mode. 24. Audio indicator,blue light flashing in unconnected state.blue light is always on when connected successfully red light is on when charging.and red light is of after full charge. Specification parameters ·Output power.6W ·Input signal:42DB ·Battery:high-performance ·large-capacity lithium battery ·Charging voltage:DC5v ·Frequency range:90Hz-18KHz ·Power supply mode: DC charging and built-in battery major function ·it adopts a high-reduction Electrostatic system ·3.7v high performance battery ·Strong sound penetration and wide coverage ·Super MP3 audio decoding technology "Full digital audio processing,clear sound quality,high sensitivity FCC Warnning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.Microsoft Word 2016 Microsoft Word 2016