Mophie Powerstation Ultra User Manual

Getting Started

Charging the Powerstation

To charge the Powerstation, connect a USB-C cable to the Powerstation and a power source. The device features LED indicators to show its charge status.

[Diagram 1: Shows connecting a USB-C cable to the Powerstation and a power source, with LED indicators.]

Checking Battery Level

Press the charge status button on the Powerstation to check its battery level. The LED indicators will display the remaining charge.

[Diagram 2: Shows pressing a button on the Powerstation to check battery level via LEDs.]

Charging Devices

Connect your devices (e.g., smartphones, tablets, laptops) to the Powerstation using appropriate USB-C cables to charge them. The Powerstation can charge multiple devices simultaneously.

[Diagram 3: Shows connecting two smartphones to the Powerstation.]

[Diagram 4: Shows connecting a tablet, smartphone, and laptop to the Powerstation.]

Warranty Information

ZAGG is dedicated to making the best quality products. This product is warranted for two years from the date of purchase. This warranty does not affect any statutory rights. Keep your purchase receipt as proof of purchase. Register your product at mophie.com/warranty.

Customer Service

• Telephone: 1-888-8mophie (1-888-866-7443)
• International: +1 (269) 743-1340
• Web: www.mophie.com/cs

Important Safety Instructions

WARNING: Read all instructions and warnings before using this product. Improper use may result in product damage, excess heat, toxic fumes, fire, or explosion, for which you are responsible, not ZAGG Inc.

• Before first use, fully charge the Powerstation until all 4 status LEDs are lit.
• Do not store the device in high-temperature environments, near fire, or in excessively hot conditions. Exposure to fire or temperatures above 212°F (100°C) may cause explosion.
• Operate the Powerstation only in open-air conditions. Do not use in enclosed, unventilated spaces like bags or pockets, as this may cause overheating and damage.
• Do not disconnect the Powerstation from a connected device while it is charging; wait until the device is fully charged.
• Be cautious of drops, bumps, abrasions, or other impacts. Discontinue use if the product is damaged (dents, punctures, tears, deformities, corrosion) and contact the manufacturer or recycle it.
• Do not expose the portable charger to rain or snow.
• Do not insert fingers or hands into the product.
• Do not disassemble, modify, or attempt to replace any part of this device.
• Refer to the manual's illustrations for charging instructions.
• Using unrecommended power supplies or chargers may pose a risk of fire or injury.
• Do not exceed the Powerstation's output rating; overloading may cause fire or injury.
• If the product is used by a minor, the adult purchaser agrees to provide supervision, instruction, and warnings.
• If the device overheats, emits odor, is deformed, or shows abnormal phenomena, stop use immediately and contact the manufacturer.
• Never dispose of batteries in garbage. Recycle used batteries at an approved center.
• Switch off the Powerstation when not in use. It will automatically shut off when disconnected from a device.

Legal and Compliance Information

This product is designed for use only with the appropriate device. Check your device packaging for compatibility. The Manufacturer is not responsible for any damages to any device incurred through the use of this product.

The Manufacturer shall not be liable for any damages you or any third party may suffer as a result of intended or unintended use, or misuse of this product in conjunction with any device or accessory other than the appropriate device for which this product is designed. If you are responsible for product use with an unintended device and damages result, you agree to indemnify the Manufacturer for any resulting injuries to any third party.

This device complies with Part 15 of the FCC Rules and RSS-Gen of IC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced technician for help.

CAUTION: To comply with the Class B digital device limits, pursuant to Part 15 of the FCC Rules, this device must be used with certified peripherals and shielded cables. All peripherals must be shielded and grounded. Operation with non-certified peripherals or non-shielded cables may result in interference to radio or reception.

MODIFICATION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device conforms to UL STD. 62368-1, CSA STD. C22.2 NO. 62368-1, and UL SUBJECT 2056.

WEEE Statement

All mophie products are marked with the WEEE symbol, indicating that this product must NOT be disposed of with other waste. Instead, it is the user's responsibility to dispose of their waste electrical and electronic equipment by handing it over to an approved re-processor, or by returning it to mophie, inc. for reprocessing. For more information about where you can send your waste equipment for recycling, please contact mophie, inc. or one of your local distributors.