Installation Guide for AVIANCE Lighting models including: HD10086, HD10086 Ainsworth 22.5 Inch 3-Light Polished Brass Outdoor Hardwired Wall Lantern, Ainsworth 22.5 Inch 3-Light Polished Brass Outdoor, Hardwired Wall Lantern, 22.5 Inch 3-Light Polished Brass Outdoor Hardwired Wall Lantern, 3-Light Polished Brass Outdoor Hardwired Wall Lantern, Polished Brass Outdoor Hardwired Wall Lantern, Brass Outdoor Hardwired Wall Lantern, Outdoor Hardwired Wall Lantern, Hardwired Wall Lantern, Wall Lantern, Lantern
2 days ago — ASSEMBLING THE FIXTURE (Fig.1). 1. Shut off the power at the circuit breaker and remove old fixture, including the single bar. Carefully unpack your new ...
ASSEMBLING THE FIXTURE (Fig.1). 1. Shut off the power at the circuit breaker and remove old fixture, including the single bar. Carefully unpack your new ...
CONNECTING THE WIRES (Fig.2). 1. Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the ...
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. HD10086 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. ASSEMBLING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker and remove old fixture, including the single bar. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation. 2. Attach the mounting screw part way into the side hole of the crook cross bar, then lock it securely with hex nut until becoming. Attach the cross bar to the junction box using two box screws. The side of the cross bar marked "GND" must face out. 3. Follow wiring instructions carefully (see fig.2). 4. Using the end of arm(A) hook the lamp body's loop, aligning the end hole of the arm(A) with the top hole of back plate, lock it securely with screw(E) and hex nut. 5. Attach the back plate of the lamp body(B) onto the junction box, aligning screws on cross bar with mounting holes and lock it securely with the ball nuts(C). 6. Install the light bulbs(Not included) in accordance with the fixture's specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING! 7. With silicone caulking compound, caulk completely around where back of cover meets with the wall surface to prevent water from seeping into junction box. FIG.1 CONNECTING THE WIRES (Fig.2) 1. Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has a ground wires (green or bare copper) connect fixture's ground wire to it. Otherwise attach the bare copper fixture wire to the green ground screw on the mounting plate. 2. Tuck the wire connections neatly into the wall junction box. FIG.2 FIXTURE WIRES Black or Smooth FIXTURE WIRES White or Ribbed HOUSE WIRES Black(Hot) HOUSE WIRES White (Neutral) FIXTURE WIRES Bare Copper (Ground) HOUSE WIRES Green or Bare Copper(Ground) Your installation is now complete. Return power to the junction box and test the fixture. Thank you for purchasing an AVIANCE product. Need assistance with parts or assembly? Please email customer service at:info@aviancelighting.net ©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING,INC. DOC202307HD10086Acrobat Distiller 9.3.2 (Windows)