
Instruction Manual for BAGTAG models including: H3750B, NOI-H3750B, NOIH3750B, Flex, Smart Electronic Luggage Labels, Flex Smart Electronic Luggage Labels
Netronix Inc H3750B NOI-H3750B NOIH3750B h3750b
File Info : application/pdf, 8 Pages, 4.78MB
DocumentDocumentDEVICE SPECIFICATIONS BAGTAG Flex BAGTAG is a registered trademark and trade name of DS TAGS GROUP B.V. 1 Chamber of Commerce 58980792 © DS TAGS GROUP B.V., 2018 Contents 1 Technical specifications 2 Regulations and conformity 3 Physical specification 4 Operating instructions 5 Attachment method BAGTAG is a registered trademark and trade name of DS TAGS GROUP B.V. Chamber of Commerce 58980792 © DS TAGS GROUP B.V., 2018 BAGTAG Flex 2 1.1 Connectivity Security Power consumption Operation lifetime Operating temperature IP rating 1.2 Display Type Protection Size Viewing angle Display colors Resolution Bluetooth Low Energy 5 .0 RFID UHF NFC 128-bit AES 0mW in normal state (display on) 0°-40° unspecified Electronic Paper Display High impact and scratch resistant cover lens 3.7" unspecified Black/White 280px x 480px 1.3 Bluetooth Type Frequencyrange 1.4 RFID Band Frequencyrange Standard Antenna Operation 1.5 Power Type Conduction range Frequency Low Energy (5 .0) 2402 - 2480 MHz Ultra-high frequency (UHF) 860 - 960 MHz EPC Class 1 Gen2, ISO/IEC 18000-6C Omnidirectional Passive(`read only' by external source/interrogators) NFC 5mm 13.56 MHz BAGTAG is a registered trademark and trade name of DS TAGS GROUP B.V. Chamber of Commerce 58980792 © DS TAGS GROUP B.V., 2018 3 2. Regulations and conformity Accordingto FAA,ICAO and IATA electronicbagtagsare considered Personal Electronic Devices (PEDs),with the added exception that they are not readily accessible during Several regulatory standards apply and are listed below. It is in any case important to note that BAGTAG2 is a passive device and does NOT contain a battery. Source IATA IATA FAA FAA FAA ICAO ICAO Document Guidance on Smart Baggage Guidance on Smart Baggage Use of PED aboard aircraft (AC 91.21-1D) Use of PED aboard aircraft (AC 91.21-1D) Use of PED aboard aircraft (AC 91.21-1D) DGP/26-WP/2 DGP/26-WP/2 Topic Advice Maximum Lithium content / battery 2 g Required battery UN 38.3 RF radiated emission limits following RTCA DO-160, section 21 Means to shut off, if active device several PED batteries lithium content 0.3 g/ battery Proposed restrictions on Electronic Bag Tag battey 0.3 g / battery Battery UN 38.3 BAGTAG n/a n/a n/a n/a n/a n/a Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Radiation Exposure Statement: The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available. BAGTAG is a registered trademark and trade name of DS TAGS GROUP B.V. 4 Chamber of Commerce 58980792 © DS TAGS GROUP B.V., 2018 3.1 Device dimensions Height Width Depth Weight 127 mm 73mm / 102 mm 11 mm 110 g 102 mm 18 mm 127 mm 3.2 Packaging dimensions Giftbox (inner) Giftbox (outer) Strap ejector tool EBT device Total 75 g 30 g 1 g 110 g 216 g 200 mm 30 mm 140 mm 73 mm 11 mm BAGTAG is a registered trademark and trade name of DS TAGS GROUP B.V. 5 Chamber of Commerce 58980792 © DS TAGS GROUP B.V., 2018 4. Operating instructions Updating the display The display of the device can be updated by using the BAGTAG app or by using one of the supported airline apps. From the app, initiate the update process. Click on "Activate with NFC", the interface is showing "Ready to Scan" Position the phone on top of the BAGTAG Flex. See illustration for guidance. The blue light indicates the device is receiving power via NFC. The data is now being transferred via Bluetooth. Hold the phone in position during the update. When the process is complete, remove the phone. BAGTAG is a registered trademark and trade name of DS TAGS GROUP B.V. Chamber of Commerce 58980792 © DS TAGS GROUP B.V., 2018 Common Android usage Apple iPhone usage 6 5. Attachment method Attach Wrap the strap around the suitcase handle and attach back in the device. Pull to tighten. Disconnect Use the included securitypin to unlock the attachment mechanism. Pull the strap out. BAGTAG is a registered trademark and trade name of DS TAGS GROUP B.V. 6 Chamber of Commerce 58980792 © DS TAGS GROUP B.V., 2018 www.bagtag.com/industry