Installation Guide for AViANCE models including: 46927, 46928, 46037, 46038, 46147, 46148, HD67592 14 in 4-Light Brushed Nickel, HD67592, 14 in 4-Light Brushed Nickel, Light Brushed Nickel, Brushed Nickel
há 16 horas — MOUNTING THE FIXTURE (Fig.1). 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. HD67592 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. MOUNTING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. 2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation. 3. Thread the two mounting screws about 1/4" into the pre-drilled holes in the mounting plate spaced the same distance apart as the holes in the canopy(A). 4. Attach the mounting plate to the Junction Box with the two Junction Box Screws as shown. The side of the mounting plate marked "GND" must face out. The junction box is not included. 5. Slide the electrical wires through the tube(B) and canopy(A), then by turning it clockwise until tight. 6. While holding the lamp body towards the ceiling, connect the electrical wires as Shown in Fig.2, making sure that all wire nuts are secured. You may have to wrap the connections with electrical tape. If your outlet has a ground wire (green or bare copper), connect the fixture ground wire to it. Otherwise connect fixture's ground wire directly to the Mounting strap with the green screw provided. After wires are connected, tuck them carefully inside the Junction Box. 7. Raise the canopy on to the Junction box, aligning screws on mounting plate with mounting holes in canopy and lock it securely with the column nuts(D). 8. Install the light bulbs(not included) in accordance with the fixture's specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE! Your installation is now complete. Return power to the junction box and test the fixture. FIG.1 Green Screw (GND) D Junction Box (Not included) Mounting screw Junction Box (Screw) A B C FIG.2 FIXTURE WIRES BLACK FIXTURE WIRES WHITE HOUSE WIRES Black (Hot) HOUSE WIRES White (Neutral) FIXTURE WIRES GREEN Thread (Ground) HOUSE WIRES Green or Bare Copper(Ground) Thank you for purchasing an AVIANCE product. Need assistance with parts or assembly? Please email customer service at:info@aviancelighting.net ©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING,INC. DOC202503HD67585Acrobat Distiller 9.3.2 (Windows)