Installation Guide for PDQ Locks models including: SDE-0002, SDE-0002 SDE Tubular Cylindrical Lock, SDE Tubular Cylindrical Lock, Tubular Cylindrical Lock, Cylindrical Lock, Lock
SDE Tubular Cylindrical Lock | PDQ Locks
File Info : application/pdf, 2 Pages, 322.01KB
DocumentDocumentSDE Installation Instructions Electronic Tubular Lock Phone: 866-874-3662 | www.pdqlocks.com 1. Adjust the Latch Backset Length · Measure your door backset. · Adjust the backset to the corresponding latch length. 2-3/8"(60mm) 2-3/4"(70mm) 2. Install the Latch Bolt · Install the latchbolt into the door with 2 #8x3/4" sheet metal screws and tighten it. (Refer to 1) 3. Install the Exterior Assembly · Install the waterproof gasket to exterior assembly. (Refer to 2) · Install the square shaft into the spindle hub. The pin should be in the vertical position. (Refer to 3) · Install the 2 silver positioning pins. (Refer to 4) · Install the exterior assembly with the 3 brass threaded inserts. (Refer to 5) (The 3 longer brass inserts are for wider doors) · Pass the cable above the latchboth assembly and install the exterior assembly. SDE-0002 Rev0 SDE Installation Instructions Electronic Tubular Lock 4. Install the Interior Assembly · Install the waterproof gasket. (Refer to 6) · Connect the cable to the top of the assembly. (Refer to 7) · Neatly route the wire inside the escutcheon. · Secure the exterior assembly with 3 M5x65 flat head machine screws. (Refer to 8) (The 3 longer M5x65 flat head machine screws are for wider doors) Phone: 833-2-PDQTEC | www.pdqlocks.com 5. Install the Batteries · Insert 4 AA alkaline batteries. (Refer to 9) · Install the battery cover. (Refer to 10) The Installation is Complete. SDE-0002 Rev0