ELEVON
A cloth bag is included with the product.
Safety Precautions
When using electrical products, especially when children are present, basic safety precautions should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
DANGER: To reduce the risk of electrocution:
- Always unplug this product immediately after using.
- Do not use while bathing.
- Do not place or store product where it can fall or be pulled into a tub or sink.
- Do not place in or drop into water or other liquid.
- Do not reach for a product that has fallen into water. Unplug immediately.
WARNING: To reduce the risk of burns, electrocution, fire, or injury to persons:
- A product should never be left unattended when plugged in.
- Close supervision is necessary when this product is used by, on, or near children or invalids.
- Use this product only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
- Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the product to a service center for examination and repair.
- Keep the cord away from heated surfaces.
- Never block the air openings of the product or place it on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, and the like.
- Never use while sleeping or drowsy.
- Never drop or insert any object into any opening or hose.
- Unplug this product before filling. Fill (reservoir) with water only unless otherwise specified by manufacturer. Do not overfill (or specify filling instructions).
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- Use this product only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
- Do not plug this device into a voltage system that is different from the voltage system specified on the device or charger.
- For household use only. DO NOT use the product outdoor.
SAVE THESE INSTRUCTIONS
Troubleshooting Guide
| Problem | Cause | Solution |
|---|---|---|
| The device is not operating (starting) | The power plug is not tightly plugged in or there is a problem with the plug or socket. | Check if the power plug is in good contact with the socket. |
| There is not enough or no water coming from the device. | 1. The water tank has not been installed correctly, meaning that the pipe slot is not pushing the valve open. 2. The handle switch has not been turned on. 3. Not enough time has passed since the water was turned on. |
1. Use a slight amount of force to press the water tank down vertically so that the bottom edge of the tank is fully fitted with the top of the device. 2. Push the handle switch to the "OFF" or "ON" position. 3. Turn the switch knob clockwise to the furthest point and turn the handle switch on. Under normal conditions, water should flow for around 15 seconds. |
| Water is leaking between the nozzle and the handle switch or the nozzle was flushed out by water pressure during operation | The nozzle was not installed properly. | Install the nozzle in the proper position (you should hear a "clicking" sound). |
| The handle is leaking water | 1. There is ponding in the cavity after the handle is cleaned. 2. When the nozzle is not inserted, the water in the tank flows into the handle cavity through the device pipe. |
1. It is normal for there to be water in the handle cavity after cleaning. 2. Install the nozzle before use. |
| Water is leaking from the pipe | The pipe is damaged | Seek a replacement or after-sales repair from the seller. |
| The device automatically shut down | The device has a configured timed shutdown. | This is a part of normal operations. Simply turn the device back on. |
| The device is making noises | This is a part of normal operations. | When the product is operating, it may generate a noise of 75 dB. The device is operating normally. |
Product Specifications
- Dimensions: 120x150mm ± 2mm
- Weight: 105g
- Certifications: ROHS/REACH compliant