User Manual for CANNABIS HARDWARE models including: Tegridy 20, DP-TC04R115, TC04R115, Tegridy 20 Ton Rosin Press, Tegridy, 20 Ton Rosin Press, Rosin Press, Press
Rosin Press Additional information – Cannabis Hardware
Rosin Press Additional information | Cannabis Hardware
Rosin Press Tegridy and BVA lines of Rosin Presses Introduction First, I would personally like to extend my thanks for choosing Cannabis Hardware as your source for all things Rosin Press. We are very proud of how far we have come in evolving our products and are extremely excited to share it with you. The design of the Rosin Press is the culmination of 25 years of engineering and machining experience which started in the Orthopedic and Dental fields. Nowadays, I am extremely grateful to merge my two passions in life, machining and cannabis, and now I get to share my contribution with our ever-growing industry. I hope your new Rosin Press brings you a lifetime of production and fun! Edwyn Pyron Owner and CEO About your Packaging When you purchase a Rosin Press from NewVape, you will receive two boxes with all the contents. These contain everything you need to get started. - (1) Assembled Tegridy 20 Rosin Press body - (4) Gravity drip enabling feet - (1) Custom Engraved Wooden Handle - (2) Brackets for the Wooden Handle - (1) PID Controller with 4 heaters and two thermocouplers - (1) Upgraded Pump Handle - (1) Tool Bag (4 (+1) allen screws for handle and 8 (+1) for feet and 2 allen wrenches) Assembling the "Gravity Drip" Feet These are the parts you will need (included): - 4 Gravity Drip Feet - 8 Short Allen Screws - 1 Allen Wrench Install each foot by finger tioghtening the allen screws first, then use the allen wrench to tighten them. This is what your press should look like with the "Gravity Drip Feet" installed. Assembling the Custom Engraved Wooden Handle You will need these parts (included): - 4 Long Allen Screws - 2 Handle Brackets - 1 Allen Wrench Align the holes in the bracket with the holes on the top of the press and run the longAllen screws until it catches the bracket. Use Allen Wrench to tighten in place, then hold the second bracket in place with the handle installed. Use remaining long Allen Screws to tighten the second bracket in place. Assembling the Custom Pump Handle Insert Handle in Pump Align hole in handle with the pump insert hole Tighten the Pump Handle in place. This is what it should look like. Assembling the PID Controller to the Press It does not matter which set of heaters you decide to assign to the top and bottom plates. However, it is a good idea to label them so as to remain consistent. Once you have decided which set of heaters to assign to each place, go ahead and insert them. Each set of heaters goes into one plate. There is a thermocoupler that tags along with each set of heaters. These help in giving an accurate temperature reading back to the controller. The need to be threaded into the middle hole on each plate. On each side of each plate there are recessed screws which will tighten onto the heating rod from the inside and keep them in place. Check that you have done it correctly by lightly pulling on the heater rods. If they do not come out of the plate, you are set. This is what it should look like with the heating rods and thermocoupler installed correctly. How to adjust temperature on PID controller Here are some temperature recommendations to get you startedAdobe PDF Library 16.0.7 Adobe InDesign 17.3 (Windows)