User Manual for LEXON models including: 2ARD3-LD149, 2ARD3LD149, ld149, LD149 Bluetooth and Compact Wireless Mouse, LD149, Bluetooth and Compact Wireless Mouse, Compact Wireless Mouse, Wireless Mouse, Mouse
LEXON LD149 MUSO 2ARD3-LD149 2ARD3LD149 ld149
This device in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. All essential.
LD149 MUSO Design by Manuela Simonelli & Andrea Quaglio English Product overview 1. Left and right mouse buttons 2. Scroll wheel 3. Low battery LED indicator 4. USB-C charging port First setup 5. Bluetooth pairing button 6. Optical sensor lens 7. On/Off slider switch 8. Charging LED Product specifications Material: Synthetic leather / Aluminum / ABS Weight: 85 g Dimensions: 11.5 x 6.6 x 3.1 cm Sensor technology: Smooth optical sensor DPI (Min/Max): -/+ 1200 Number of buttons: 3 (Left/Middle/Right) Scroll Wheel: Yes, 3D Battery life: Up to 6 months, depending on use Connection type: Bluetooth Wireless range: 33ft (10m) Connect / Power: Yes, ON/OFF switch Compatibility: macOS 10.10 or later / Windows® 10,11 or later / ChromeOS / Linux® EUROPEAN UNION CE DIRECTIVE This device in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. All essential radio test suites have been carried out. This restriction will be applied to all Member States of European Union. The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction. Declaration of Conformity Hereby, LEXON declares that the product type LD149 is in compliance with Directives 2014/53/EU & 2011/65/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.lexon-design.com/assets/certifications-ce-luma.pdf UK CONFORMITY ASSESSMENT The device is in compliance with the essential requirements and other relevant provisions of the UK Radio Equipment Regulations SI 2017:1206 (as amended). The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction. Declaration of Conformity: Hereby, LEXON declares that the product LD149 is in compliance with the following Regulations: Radio Equipment Regulations 2017, Electrical Equipment (Safety) Regulations 2016 and The Restriction of the Use of Certain Hazardous Substances in Electrical and Electrical Equipment 2012. The Full test of the UK declaration of conformity is available at the following internet address: https://www.lexon-design.com/assets/certifications-ce-luma.pdf WPT: RX Frequency Range: 110-148 KHz Bluetooth Transmitter power8.12dBm(for EU/UK only) TX/RX Frequency Range: 2400-2480MHz DISPOSAL AND RECYCLING INFORMATION After the implementation of the European Directive 2012/19/EU in the national legal system, the following applies: electrical and electronic devices may not be dis-posed of with domestic waste. Consumers are obliged by law to return electrical and electronic device at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details to this are defined by the national law of the respective country. This symbol on the product, the instruction manual or the package indicates that a product is subject to these regulations. By recycling, reusing the materials or other forms of utilizing old devices, you are making an important contribution to protecting our environment. USA - FCC STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Notice: Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/ TV technician for help. RF exposure statements The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. CANADIAN COMPLIANCE STATEMENT This device complies with Industry Canada license-exempt RSSs. Operation is subject to the following two conditions: 1) This device may not cause interference, and 2) This device must accept any interference, including interference that may cause undesired operation of the device. This Class B digital apparatus complies with Canadian ICES-003. Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisee aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible d'en compromettre le fonctionnement. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: This device may not cause interference. This device must accept any interference, including interference that may cause undesired operation of the device. RF exposure statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. Cet appareil contient des emetteurs / recepteurs exemptes de licence conformes aux RSS (RSS) d'Innovation, Sciences et Developpement economique Canada. Le fonctionnement est soumis aux deux conditions suivantes: Cet appareil ne doit pas causer d'interferences. Cet appareil doit accepter toutes les interferences, y compris celles susceptibles de provoquer un fonctionnement indesirable de l'appareil. Declaration d'exposition RF: L'appareil a ete evalue pour repondre aux exigences generales d'exposition aux RF. L'appareil peut etre utilise dans des conditions d'exposition portable sans restriction.