FCC ID: 2BHJR-MS190
Test Setup Photos for Conducted and Radiated Emissions
Conducted Emissions
The image shows a laboratory environment set up for conducted emissions testing. A table holds electronic equipment, including the device under test and associated power supplies or measurement instruments. Cables are connected between the devices. The room appears to be a shielded or controlled environment suitable for electromagnetic compatibility (EMC) testing.
Radiated Emissions (30MHz-1GHz)
This image displays an anechoic chamber, characterized by its RF-absorbent foam panels on the walls, floor, and ceiling. At the center, a turntable is visible, designed to rotate the device under test. A measurement antenna is positioned at a specific distance from the turntable, ready to capture radiated electromagnetic signals. This setup is used for measuring emissions within the frequency range of 30 MHz to 1 GHz.
Radiated Emissions (Above 1GHz)
Similar to the previous setup, this image captures an anechoic chamber with RF-absorbing materials. The device under test is represented by a large, white, rectangular block, placed on a non-conductive pedestal atop the turntable. A measurement antenna is also visible, indicating the setup for measuring radiated emissions at frequencies above 1 GHz.
