Curtain Rod Installation
Hardware Included
- Three-piece rod (x2)
- Back plate (x2)
- Bracket (x1)
You Will Need
- Wall Screws (x6)
- Anchors (x6)
- Thumb Screws (x2)
- Drill with 1/4 inch (6mm) drill bit
- Screwdriver
Installation Steps
Step 1: Prepare Mounting Points
Unscrew the back plate from the rod. Use the back plates as a guide to locate the desired positions on the wall. Create markings on the wall for the mounting screws.
Step 2: Drill Pilot Holes
Set aside the back plates. Drill holes into the wall at the marked locations using a 1/4 inch (6mm) drill bit.
Step 3: Attach Back Plates (Top View)
Insert wall anchors into the drilled holes. Wall anchors are not necessary if screwing into a wooden batten. Attach the back plate to the wall using the provided screws.
Step 4: Assemble and Mount Rod
A. Connect the three-piece rod together. The rod with the largest diameter is the middle piece. B. Slide the assembled rod into the back plates.
Step 5: Position Center Bracket
Place the support bracket in the center. Create markings on the wall for the mounting screws of the center bracket. Temporarily remove the assembled rod from the back plates.
Step 6: Attach Center Bracket (Side View)
Drill holes into the wall where marked for the center bracket, using a 1/4 inch drill bit. Insert wall anchors if needed (not necessary if screwing into wood). Attach the center bracket to the wall using the provided screws.
Step 7: Hang Curtains
Remove the right rod piece from the middle rod. Slip the curtain panel onto the rod. Slide the right rod piece back into the middle rod. Place the rod with the curtain into the back plates and the center bracket.
Step 8: Secure the Rod
Tighten the screws on the back plates and the center bracket to secure the rod in place.
Step 9: Adjust Panels
Wrap and adjust the curtain panels around both ends of the rod so that the panels hang flush with the wall.




