User Manual for super bright leds models including: IT5-xKx Series, Linkable Integrated T5 Linear LED Light

User Manual - Source

User Manual. Important: Read all instructions prior to installation. IT5-xKx Series. Safety and Notes. Included Accessories. Optional Accessories. Max Run¹.

User Manual

WIFI-CON User Manual Important: Read all instructions prior to installation. IT5-xKx Series Safety and Notes Included Accessories Optional Accessories Specifications Max Run¹ 4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com Rev Date: V1 12/09/2020 ...

Download IT5-xKx User Manual

T5 Integrated LED Light Fixture - Multipurpose Linkable Linear Light - 400 lm/ft. | Super Bright LEDs

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized



File Info : application/pdf, 1 Pages, 647.71KB

Document Document

User Manual

Important: Read all instructions prior to installation.
Linkable Integrated T5 Linear LED Light

IT5W-xIKFIx-CSOeNries

Safety and Notes

· Product should be installed in accordance with applicable national, state, and local electrical codes.
· To reduce the risk of electric shock, ensure that the main power source is switched off before performing any installation or wiring procedures.
· Product is for use in dry, indoor locations only.
· When installing multiple lights in a run, make sure to check for voltage drop. Minimum voltage must be maintained to avoid damaging lights. Current for a single run of lights should not exceed the numbers listed in the table below.

Included Accessories
· Surface mounting bracket (x2) · Mounting screws (x2) · Tube to tube butt connector (x1) · 6 in. pigtail power adapter (x1) · Tube endcap (x1)

Specifications

IT5-xKx

Operating Temperature

-4­131° F (-20­55° C)

IP Rating

IP40

Check product label for specific electrical specifications related to installation. Improper installation will void warranty.

Optional Accessories
· 30 cm Interconnect (IT-I30) · 100 cm Interconnect (IT-I100) · 100 cm Powercord (IT-P100)

Max Run¹

Part Number 12 VDC 24 VDC 36 VDC

IT5-xK12

6

12

18

IT5-xK18

4

8

12

IT5-xK24

3

6

9

IT5-xK36

3

5

7

IT5-xK48

2

3

5

¹Do not exceed 2 A total load if combining multiple lengths of lights in one run.

Wiring Diagram
Green - N/C White - Non-polarized

Green - N/C

Black - Non-polarized

Black - Non-polarized White - Non-polarized

Installation Instructions
1. Drill pilot holes for mounting screws and install mounting clips approximately 8" from ends of fixture. This will allow the fixtures to slide into position while still maintaining adequate support. Repeat for all fixtures in the run.
2. Snap fixtures in place. Make connections between fixtures using supplied butt connector or optional interconnects.
3. Use tube end cap to cover unused power connector on the last fixture in the run.
4. Connect powercord to 12­36 VDC power source and plug into the first light in the run.

A A
Mounting Bracket Installation

Endcap Single Fixture Installation

or Multiple Fixture Installation

Finished Run

Rev Date: V1 12/09/2020 4400 Earth City Expy, St. Louis, MO 63045

866-590-3533

superbrightleds.com