YCOO Pokibot Interactive Robot

Safety Precautions

• Remove batteries from the toy when not in use.
• Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
• Always remove batteries from the toy when it is not being used for a long period of time.
• Wipe the toy gently with a clean damp cloth.
• Keep the toy away from direct sunlight and/or direct heat.
• Do not submerge the toy into water as it can damage the electronic assemblies.
• WEEE (Waste Electrical and Electronic Equipment): When this appliance is out of use, please remove all batteries and dispose of them separately. Bring electrical appliances to the local collecting points for waste electrical and electronic equipment. Other components can be disposed of in domestic refuse.
• Battery Cautions:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before being charged.
• Rechargeable batteries should be charged under adult supervision.
• Different types of batteries or new and used batteries are not to be mixed.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with correct polarity (+ and –).
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
• Notes:
• Parental guidance is recommended when installing or replacing batteries.
• Replace the battery as soon as the function becomes impaired.
• Instruction sheet and packaging must be retained as they contain important information.
• Users should keep strict accordance with the instruction manual while operating the product.
• Under the environment with electrostatic discharge, the sample may malfunction and require user to reset the sample.
• Warning: CHOKING HAZARD - Small parts. Not for Children under 3 years.

FCC Compliance

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Delivery Contents

• POKIBOT x 1
• Instruction manual x 1

Part Identification

Refer to diagrams for specific part identification (e.g., Power Switch, Microphone, Record Button, Battery Compartment).

Battery Installation

1. Make sure the power switch is on the “OFF” position.
2. Use a screwdriver to loosen the screw on the battery compartment in an anti-clockwise direction.
3. Put 1 x “AAA” battery (not included) in the battery compartment as per the polarity shown inside.
4. Tighten the screw in a clockwise direction.
5. Tips: Best & maximum performance can be obtained by using new alkaline batteries. Remove batteries by pulling up on one end of each battery positive by hand. DO NOT remove or install batteries using sharp or metal tools.

General Features

POKIBOT is an interactive robot that can dance, play voice recordings & sound effects. POKIBOT reacts to different kinds of inputs:

• Sound Input: Reacts differently to sound patterns such as taps, knocks, and claps.
• Voice Recording: Converts your input message to a robotic voice and plays it back.
• Interactivity: Can interact with other POKIBOTs or Silverlit Robot items like Maze Breaker & MacroBot.
• Mobile App Control: Can be controlled by a mobile phone app available in iOS & Android versions.

How to Play

6.1 START TO PLAY: IDLE MODE

Turn the Power switch to ON position. POKIBOT will be ready for play and will occasionally move and talk.

6.2 ACTION MODE

POKIBOT responds to sound inputs such as finger tapping or clapping:

• Single Tap (or clapping hands): Plays back recorded messages.
• More than Two Taps (or clapping hands): Responds with movements or a dance.

6.3 TALKBACK MODE

• POKIBOT can record up to 3 messages, with each recording up to 3 seconds.
• Press the REC button once to start recording; POKIBOT’s face will flash rapidly.
• Speak a message after POKIBOT generates a BEEP sound.
• POKIBOT will generate a BEEP-BEEP sound when the message recording is finished.
• POKIBOT will playback the last message automatically to confirm successful recording.
• POKIBOT will automatically go back to idle mode once playback is complete.
• To clear recorded messages, record new messages to replace them or press & hold the button for 5 seconds until POKIBOT generates a BEEP-BEEP-BEEP sound.

6.4 COMPANION MODE

Follow these steps to pair up POKIBOTs:

1. Put Pokibots together within 12 inches (approx. 30 cm) of one another.
2. Switch ON one of the POKIBOTs.
3. Switch ON another POKIBOT within 2 seconds. You will hear a sound effect from both POKIBOTs simultaneously, indicating successful pairing.
4. Repeat step 3 for each POKIBOT you want to add for pairing.
5. If either one or both POKIBOTs start moving or talking without a sequence, they have failed to pair up. Repeat from step 2.
6. Once all POKIBOTs are paired, they will interact with each other and respond to sound inputs as in ACTION mode.

6.5 MOBILE APP

• Download the App from Apple’s App Store or Google Play.
• Direct control and group play features are available in the mobile App. Refer to the instructions in the info page for details.

POWER SAVING

• POKIBOT will generate a reminder sound if no input is received, repeating the sound every 15 seconds.
• POKIBOT will go to sleep after generating the reminder sound 3 times.
• To wake up the POKIBOT, turn the power switch to “OFF” and then “ON” again.