User Guide for HYPER TOY models including: HRC1411, 2AMOVHRC1411, HRC1411 Remote Control Flying Eagle, Remote Control Flying Eagle, Flying Eagle, Eagle

HYPER EAGLE IM ENG WMCA

User Manual

HYPER TOY COMPANY HRC1411 RC FLYING EAGLE 2AMOVHRC1411 2AMOVHRC1411 hrc1411

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized



File Info : application/pdf, 2 Pages, 895.62KB

Document Document

This device complies with Industry Canada licence-exempt RSS 210 standard. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

MADE IN CHINA

LITHUM BATTERY USB CHARGER

CONTENTS

3.7V 100mAh Rechargeable Batteries x 2

RC Eagle Remote Controller Instruction Manual

USB Charger

BATTERY INSTALLATION

- 1.5V AAA LR03 + + 1.5V AAA LR03 -

1) Unscrew on the battery cover by screwdriver and remove the battery cover.
2) Put 2 1.5V AAA batteries in the battery slots with correct polarity.
3) Slide the battery cover back to the remote controller and tighten the screw.

Back of Remote Controller

Charging Battery: 20 mins 1) Connect Battery to the USB charger. 2) Connect USB charger to power source.

Green Indicator light

Infrared obstacle avoidance device
ON / OFF Hold: ON / OFF
Battery Slot Bolt

Green Indicators light: Flashing: Remote Controller Pairing. Light On: Remote Controller Paired.
Installing Battery to RC Eagle:
1) Unscrew the Bolt on the bottom of the RC Eagle.
2) Slide the Battery in the battery slot and connect it to the RC Eagle.

3) Tighten the bolt until the battery cannot slide out.

1

2

3

Side of RC Eagle

FUNCTIONS
Red Indicators light Flashing: Pairing. Light On: Paired.
Start Elliptical flight Flying Left Circle

Joy stick UP: Speed Up Down: Slow Down
ON / OFF Hold: ON / OFF
Flying Right Circle
Figure 8 Flying

Remote Controller Remote controller and RC Eagle will turn OFF automatically when it idle over 12 minutes.

To Start Playing:
1) Turn on the remote controller and RC Eagle.
2) Push Joy stick UP and DOWN to pair.
3) Press Start button or gently move RC Eagle UP and DOWN by hand until wings start flapping.
4) Gently throw RC Eagle forward to begin Fly.

To End Playing: 1) Put RC Eagle up side down until wings stop flapping. 2) Turn off the remote controller and RC Eagle.
RC Eagle has altitude sensor, so it flies in the same altitude all the time.