OPERATING INSTRUCTIONS
DXBC15002 / DXBC15004 RATCHET STRAP
READ ALL WARNINGS CAREFULLY AND COMPLY WITH ALL WARNINGS. FAILURE TO DO SO MAY RESULT IN DAMAGE TO THIS PRODUCT, PERSONAL PROPERTY AND/OR PERSONAL INJURY.
*DO NOT EXCEED THE WORKING LOAD LIMIT OF THE STRAP; TAKING INTO ACCOUNT THE STRAP, THE LOAD, THE VEHICLE ANCHOR POINTS, STRAP CONFIGURATION AND ANGLE, ETC.
TO TIGHTEN:
WITH RATCHET CLOSED, THREAD STRAP THROUGH THE SLOT IN THE CENTER OF THE RATCHET DRUM.
Image description: A hand is shown threading the yellow webbing strap through the central slot of the black ratchet mechanism.
PULL WEBBING THROUGH, REMOVING THE SLACK.
Image description: Webbing is being pulled through the ratchet mechanism to remove slack and tighten the strap.
TO TIGHTEN, RAISE AND LOWER RATCHET HANDLE; DO NOT OVERTIGHTEN. (MAKE SURE TO HAVE A MINIMUM OF 2 FULL WRAPS OF WEBBING AROUND THE DRUM.)
Image description: A hand is shown operating the ratchet handle up and down to tighten the strap. The text advises a minimum of 2 full wraps of webbing around the drum for secure tightening.
KEEP RATCHET IN CLOSED POSITION TO LOCK.
Image description: The ratchet mechanism is shown in its final, closed, and locked position, securing the strap.
TO RELEASE:
PULL UP ON THE RELEASE BAR AND HOLD.
Image description: A hand is shown pulling up on the release bar of the ratchet mechanism.
WITH THE RELEASE PULLED UP, PUSH FORWARD UNTIL THE RATCHET IS COMPLETELY FLAT AND OPEN.
Image description: With the release bar held up, the ratchet mechanism is pushed forward until it lies flat and open, releasing the tension.
GRAB WEBBING AND PULL AWAY FROM THE RATCHET HEAD TO RELEASE.
Image description: The webbing is shown being pulled away from the ratchet head to fully disengage and release the strap. A directional arrow indicates the pulling motion.
GUARANTEED TOUGH:
DEWALT® Straps: Automotive Specialty and Cargo Solutions | DEWALT® Straps
