Lark Manor 534-913 Coffee Table Assembly Instructions
Product Information
Model: 534-913
Brand: Lark Manor
Tools Required
- Allen Wrench (Provided, Part G) ?
- Allen Key (Provided, Part H) ?
- Phillips Screw Driver (Not Provided)
Before You Start
- Check the hardware against the hardware list to make sure all items are present.
- Assemble your furniture on a soft, flat surface to avoid scratching the finish.
- CAUTION: Do not over tighten screws, nuts or bolts during assembly.
- Your furniture may require occasional tightening.
Assembly Instructions
- Turn the table on to a clean soft surface.
- Attach the legs to the Table Top using Hex nuts (B), Lock Washer(E), Flat Washer (F) and using Wrench(G) (Do not tighten completely yet). As shown in Figure 1.
Diagram Description: Illustrates attaching a leg to the underside of the tabletop. A leg is shown connecting to a corner of the tabletop. Hex nuts (B), Lock Washers (E), and Flat Washers (F) are used with a Wrench (G) to secure the leg.
- Attach bottom shelf to the legs using Bolt (A), Lock Washer(C), Flat Washer (D) and using Allen Key(H) (Do not tighten completely yet). As shown in Figure 2.
Diagram Description: Shows the attachment of the bottom shelf to the assembled legs. Bolts (A), Lock Washers (C), and Flat Washers (D) are used with an Allen Key (H) to connect the shelf to the legs.
- Tighten all bolts using Wrench(G) and Allen Key(H) after completing step 3.
- Attach the Casters (J) to the bottom shelf using Screw (I). As shown in figure 3.
Diagram Description: Depicts attaching casters to the bottom shelf. Casters (J) are screwed into the designated holes on the underside of the bottom shelf using Screws (I).
- Set table back up right.
Hardware List
| Part | Description | Quantity |
|---|---|---|
| A | ? Ø1/4"x3/4" Bolt | 4pcs |
| B | ? Ø5/16" Hex Nuts | 4pcs |
| C | ⚙️ Ø1/4"x10mm Lock Washer | 4pcs |
| D | ⚙️ Ø1/4" x16mm Flat Washer | 4pcs |
| E | ⚙️ Ø5/16"x13mm Lock Washer | 4pcs |
| F | ⚙️ Ø5/16" x19mm Flat Washer | 4pcs |
| G | ? 13mm Wrench | 1pc |
| H | ? 1/4"x100mm Allen Key | 1pc |
| I | ? Ø5/32"x18mm Screw | 16pcs |
| J | ? Casters (55x64x64mm) | 4pcs |








