User Manual for FOAMit models including: SP-5N, SP-5NK, SP-5NV, 5 Gallon Air Operated Portable Spray Equipment, SP-5NV 5 Gallon Air Operated Portable Spray Equipment, Air Operated Portable Spray Equipment, Portable Spray Equipment, Spray Equipment
5 Gallon Spray Unit - FOAMit
USER MANUAL MODEL NUMBER: SP-5N SP-5NK SP-5NV AND RELATED UNITS 5 Gallon Air Operated Portable Spray Equipment English (Original Instructions) User Manual: Rotomolded Portable Spray Units | English READ ALL INSTRUCTIONS BEFORE OPERATING EQUIPMENT WARNING Read this manual completely and understand the machine before operating or servicing it. · Read all instructions before installing or operating unit. · Always wear appropriate personal protective equipment (PPE) when operating or servicing unit. · Always follow all chemical safety precautions and handling instructions provided by the chemical manufacturer and Safety Data Sheet (SDS). · Never point the discharge trigger gun at yourself, another person, or any object you do not want covered in chemical. · Always depressurize unit after use (as described in the After Use Instructions), and store unit depressurized. · Do not exceed an incoming air pressure of 100 psi (7 bar). · Do not exceed a fluid temperature of 100°F (37°C). · Only use clean and dry air. Air must be filtered and free of moisture or pump life will be diminished. If needed, install an air dryer before unit. · Do not use an air lubricator before the unit. Specifications: Hose .............. 30 feet reinforced hose, 3/8 inch inside diameter (9 meters reinforced hose, 9.5 mm inside diameter) Tank Capacity.................................................. 5 gallons (20 liters) Spray Output....................... 2 gallons/minute (7.5 liters/minute) Spray Output Distance..................... 10 to 12 feet (3 to 4 meters) Liquid Temperature ........................ 40°F to 100°F (4.4°C to 37°C) Dimensions: Length ....................................... 25 in (635 mm) approximately Width ........................................ 14 in (356 mm) approximately Height ....................................... 22 in (559 mm) approximately Weight, including discharge hose and wand: (Empty) ................................ 31 lbs (14 kg) approximately Requirements: Compressed Air Source Requirements: Air regulator (R25) is factory set at 50 psi (3.4 bar). Operating range is 40 to 80 PSI (3 to 5 bar) with 2 CFM (56.6 l/min). Chemical Requirements: Follow all instructions from chemical manufacturer and Safety Data Sheet (SDS). Air Operated Double Diaphragm Pump Models Offered: P56: Polypropylene body with Santoprene diaphragm P56V: Polypropylene body with Viton diaphragm P56K: Polypropylene body with Kalrez diaphragm Acceptable Products: Alkaline cleaners, Caustic cleaners, Sanitizers, and Acids * D-Limonene may only be used with Kalrez pump * Chlorine may only be used with Viton or Kalrez pump DO NOT USE: All hydrocarbons PROTECT THE ENVIRONMENT Please dispose of packaging materials, old machine components, and hazardous fluids in an environmentally safe way according to local waste disposal regulations. Always remember to recycle. *Specifications and parts are subject to change without notice. Model No.: SP-5N, SP-5NK, SP-5NV Page 2 of 6 | 20220322 User Manual: Rotomolded Portable Spray Units | English READ ALL INSTRUCTIONS BEFORE OPERATING EQUIPMENT Operation Instructions Wearing all PPE and observing all safety precautions dictated by the MSDS for your chemical: 1. Fill the tank with the solution to be sprayed. 2. Connect an appropriate compressed air line into the air inlet fitting (AP25). 3. Squeeze the discharge trigger gun (PSG12) to begin spraying. After Use Instructions: 1. Flush the unit with fresh water for 5 minutes. 2. Disconnect the air line from the air fitting (AP25) and relieve any pressure remaining in the system by squeezing the discharge trigger gun (PSG12). 3. Release the discharge trigger gun (PSG12) after all pressure has been relieved from the system. Maintenance Instructions: To keep your portable unit operating properly, periodically perform the following maintenance procedures: · Check the air pump (P56/P56K/P56V) for wear and leaks. · Inspect hoses for leaks or excessive wear. Make sure all hose clamps are in good condition and properly secured. · Replace filter (AFR25) in regulator (R25) as needed. · Check the suction tube and screen for debris and clean as needed. · Drain compressor tank on a regular basis to ensure proper operation of pump. Troubleshooting Instructions: · Check to ensure that the discharge hose is uncoiled properly, and that there are no kinks that could obstruct fluid flow. · Check the air regulator bowl (ABR25) and air filter (AFR25) for debris such as water, oil, or rust particles. Clean by unthreading the air regulator bowl (ABR25) from the air regulator (R25). · Check the strainer (STR38-IL) for debris or other blockages, and clean as needed. Replace strainer if damaged. Strainer must be used. · If air passes through the pump (P56/P56K/P56V) without cycling, the pump needs to be replaced. · Check for proper air pressure on the air gauge (AG100). The air regulator (R25) is factory set at 50 psi (3.4 bar). Operating range is 40 to 80 PSI (3 to 5 bar) with 2 CFM (56.6 l/min). · If the unit operates at a reduced pressure: · Check the air compressor supplying the unit. If the pressure is less than 40 psi, turn the unit off until the compressor can catch up. · If the air supply is 50 psi (3.4 bar) or above, check the air gauge (AG100), which should read near 50 psi (3.4 bar). If the air gauge reads more or less than 50 psi (3.4 bar), adjust the pressure by turning the knob on the top of the air regulator (R25). Model No.: SP-5N, SP-5NK, SP-5NV Page 3 of 6 | 20220322 User Manual: Rotomolded Portable Spray Units | English READ ALL INSTRUCTIONS BEFORE OPERATING EQUIPMENT TANK ASSEMBLY ITEM NUMBER: TANK-5N-A JC35B TANK-5N-HNDL CST5-WHL TANK-5N SPRAY GUN ASSEMBLY ITEM NUMBER: SGA14 DISCHARGE HOSE ASSEMBLY ITEM NUMBER: H38-30 Model No.: SP-5N, SP-5NK, SP-5NV Page 4 of 6 | 20220322 User Manual: Rotomolded Portable Spray Units | English READ ALL INSTRUCTIONS BEFORE OPERATING EQUIPMENT BACK PLATE Inside View BACK PLATE Outside View TW916 SSA14 AP25 PLUG 3/4 OPTIONAL COMPONENTS WATER SEPARATOR ITEM NUMBER: WS-20CFM Model No.: SP-5N, SP-5NK, SP-5NV HBSS1238 FWP12 AIR HOSE ASSEMBLY ITEM NUMBER: AH30 Page 5 of 6 | 20220322 User Manual: Rotomolded Portable Spray Units | English READ ALL INSTRUCTIONS BEFORE OPERATING EQUIPMENT ITEM NUMBER AG100 AH30 AP25 BPS-58SO BPS-SSR CST5-WHL EC14-2 F38SS FWAX15 FWP12 H14B-H H38B-H HBSS1238 HBSSEL1814 JC35B P14 P56 P56K P56V P56-BRKT P56-BRKT-SCREW PLPF PLPF-PIN PSG12 PSGORV PW124-120 R25 AFR25 ABR25 S142058-VS SC1212 SSA14 DESCRIPTION 1.5 INCH DRY MODEL 20 DUAL SCALE GAUGE 30 ft Air Hose w/ Quick Connect Fittings PLUG 1/4 NPTM AIR FITTING - BRASS Back Panel Screw - 5/8 inch with Stand Off 1/4 INCH PUSHNUT BOLT RETAINER STAINLESS STEEL 4 INCH REPLACEMENT WHEEL FOR CST5SS AND CST5SS-L OETIKER CLAMP 13.8 STAINLESS 3/8 INCH FERRULE FLAT AXLE WASHER 7/8 ID X 1.5 OD X 0.05 THK SSFW 1/4 INCH BLUE HOSE - Available per ft 3/8 INCH BLUE HOSE - Available per ft STAINLESS HOSE BARB 1/2mpt X 3/8 barb Tariff 8479.90.9496 304 STAINLESS ELBOW 1/8 INCH NPT X 1/4 INCH HOSE BARB BLACK 3.5 INCH ONE WAY VENTED CAP POLYPROPYLENE WITH GASKET AND CHECK VALVE COUNTERSUNK PLUG-HEXAGON 1/4 5700 PUMP WITH SANTOPRENE SEALS - INCLUDES HOSE BARBS, AIR FITTING, AND AIR PORT 5700 PUMP WITH KALREZ SEALS - INCLUDES HOSE BARBS, AIR FITTING, AND AIR PORT 5700 PUMP WITH VITON SEALS - INCLUDES HOSE BARBS, AIR FITTING, AND AIR PORT PUMP BRACKET- STAINLESS STEEL HI LO SCREW FOR RETAINING P56-BRKT PORTABLE FOAMER BACK PLATE W/ HINGE AND HOLES 302 STAINLESS PORTABLE PLATE HINGE PIN Assembly with o-rings included/1/2in POLY SPRAY GUN W/ GRAY HNDL. & 316SS PSG12 VITON O RING 1/2in BLACK POLY PRO X 4in - SCH.120 - 1/2in MPTOE & 1/4in FPTOE AIR REGULATOR - SILVER COLOR - 1/4fpt TWO PORT 1/8fpt TWO PORT - INCLUDES FILTER AND BOWL AIR FILTER for R25 METAL AIR BOWL for R25 1/4-20 X 5/8 PHIL TRUSS MACHINE SCREW 18-8 W/#516 VIBRASEAL ORANGE PATCH S.S. COUPLER 1/2in BY 1/2in SS304 MALE/FEMALE ADAPTOR 1/4 NPT X 1/4 NPT SSC38 SS-TAB STR38-IL TANK-5N TANK-5N-HNDL TW916 WS-20CFM WORM GEAR CLAMP, S/S (.25-.63) STAINLESS STEEL TAB 5/8 x 3/4 WITH 1/4 INCH MOUNTING HOLE IN LINE STRAINER 3/8 BARB 20 MESH 304 STAINLESS EDPM GSKT 5 GALLON ROTO MOLDED TANK WITH HANDLE HANDLE FOR TANK-5N 1/2 INT TOOTH L/W 410SS TSUNAMI WATER SEPARATOR 20 CFM Model No.: SP-5N, SP-5NK, SP-5NV Page 6 of 6 | 20220322Adobe PDF Library 16.0.5 Adobe InDesign 17.1 (Windows)