NordBench Pro Assembly Instructions

Overview

This document provides step-by-step instructions for assembling the Nordstick NordBench Pro.

⏱️ Estimated Assembly Time: 20 minutes
? Components: 1 main unit
? Recommended: 2 people for assembly

Included Parts

• Part A: Base frame with wheels.
• Part B: Main support structure with hitch receiver attachment.
• Part C: Front support arm assembly.
• Part D: Top platform with NORDSTICK branding.
• Part F: Cylindrical component.

Hardware

• S (x1): M12x80MM bolt
• T (x2): M8 nuts
• U (x2): M8x55MM bolts
• Rx (x1): M12 nut
• X (x8): M8x40MM bolts
• Y (x1): Spacer/bushing
• O (x1): Ø8*63mm pin/bolt
• J (x1): Hex wrench/Allen key

Assembly Steps

Step 1: Base Frame Attachment

Align the base frame (Part A) with the main support structure (Part B). Secure the two connection points on Part A to Part B using bolts and nuts. Red arrows in the diagram indicate the connection points.

Step 2: Securing Main Support

Attach the main support structure (Part B) to the base frame (Part A) using one M12x80MM bolt (S) and one M12 nut (Rx). The red line in the diagram indicates the location for this connection.

Step 3: Attaching Front Support Arm

Connect the front support arm assembly (Part C) to the main structure. Use two M8 nuts (T) and two M8x55MM bolts (U) for this attachment. Red lines and circles in the diagram highlight the connection points.

Step 4: Installing Top Platform

Position the top platform (Part D) onto the main structure. Secure it using eight M8x40MM bolts (X). The diagram shows multiple connection points where bolts X are inserted.

Step 5: Final Component Installation

Attach the cylindrical component (Part F) to the main structure. Secure it using the spacer/bushing (Y) and the Ø8*63mm pin/bolt (O). The hex wrench (J) is provided for tightening fasteners.