Owner's Manual & Safety Instructions
Pittsburgh Automotive Cast Iron Barrel Pump
Model: 56816
Save This Manual
Keep this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures. Write the product's serial number in the back of the manual near the assembly diagram (or month and year of purchase if product has no number). Keep this manual and the receipt in a safe and dry place for future reference.
Document identifier: 21j
Specifications
| Specification | Details |
|---|---|
| Inlet Size | 1 1/4 IN. NPT |
| Outlet Pipe | 1 IN. |
| Dimensions | 50 IN. Height |
| Applicable Liquids | Gasoline, Kerosene, Oil, Diesel, Hydraulic fluid, Lubricating Oil, Antifreeze, Non-Corrosive Liquids |
Important Safety Information
- This product is not a toy. Do not allow children to play with or near this item.
- Do not use with water or corrosive liquids.
- Do not pump used, dirty oil or fluids in this pump.
- Keep work area clean. Cluttered areas invite injuries.
- Keep Barrel Pump and fluids away from all ignition sources and flammable materials.
- Observe work area conditions. Do not use the Pump in damp or wet locations. Don't expose to rain. Keep work area well lighted.
- Assemble and use only according to these instructions.
- Wear ANSI-approved safety goggles during assembly and use.
- Do not assemble or use when tired or under the influence of drugs or medication.
- Use as intended only.
- Inspect before every use; do not use if parts are loose or damaged.
- Maintain product labels and nameplates. These carry important safety information. If unreadable or missing, contact Harbor Freight Tools for a replacement.
Assembly & Operation Instructions
Diagram Description
The diagram shows a manual barrel pump. Key components labeled are: Pump Body, Handle, Barrel Bracket, Suction Pipe, Butterfly Screw, Delivery Spout, and Threaded Outlet.
Assembly
- Slide Barrel Bracket onto Suction Pipe with threaded side down.
- Insert Suction Pipe into barrel.
- Screw Barrel Bracket into barrel.
- Tighten Butterfly Screw.
- Screw Pump Body onto top of Suction Pipe.
- Slide Handle onto Pump Body shaft.
- Tighten bolt.
- Screw Delivery Spout to Pump Body.
Operation
- Assemble Barrel Pump as described.
- Turn Discharge Spout upwards and pour in a few drops of applicable liquid.
- Attach Hose to end of Delivery Spout (if needed).
- Place container under Delivery Spout or hose end.
- Submerge lower half of Suction Pipe into applicable fluid to transfer.
- Rotate Handle clockwise.
- Remove Pump and wipe dry.
Note: Avoid pumping water or dirty residue through Barrel Pump. Raise bottom of Suction Pipe above the dirty residue.
Maintenance Instructions
⚠️ Procedures not specifically explained in this manual must be performed only by a qualified technician.
⚠️ AWARNING TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Do not use damaged equipment. If abnormal noise or operation occurs, have the problem corrected before further use.
- Before each use, inspect condition of Pump. Check for broken or bent parts, loose or missing parts and any condition that may affect proper operation of product. If a problem occurs, correct before further use.
- Periodically, use a light lubricant on Handle's pivot parts.
- Keep suction and delivery ports free of dirt and debris.
- After each use, wipe off unit. Store in a clean dry place out of reach of children.
Record Serial Number
Record Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. Specify UPC 792363568166 when ordering parts.
