User Guide for Autel Intelligent Tech models including: MS906TS2121, WQ8-MS906TS2121, WQ8MS906TS2121, MS906 Pro-TS MaxiSys OBD2 Scanner, MS906 Pro-TS, MaxiSys OBD2 Scanner
Autel Intelligent Tech. Corp., Ltd. MS906TS2121 AUTOMOTIVE DIAGNOSIS & ANALYSIS SYSTEM WQ8-MS906TS2121 WQ8MS906TS2121 ms906ts2121
Autel Intelligent Tech. Corp., Ltd. MS906TS2121 WQ8-MS906TS2121 WQ8MS906TS2121 ms906ts2121
FCC STATEMENT : Changes or modifications not expressly approved by the party responsible for compliance IC STATEMENT : This device contains licence-exempt transmitter(s)/receiver(s) that comply with could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: A (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. (2) this device must accept any interference received, including interference that may cause L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme undesired operation. aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : 1) L'appareil ne doit pas produire de brouillage; 2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le B Note: This equipment has been tested and found to comply with the limits for a Class B brouillage est susceptible d'en compromettre le fonctionnement. digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Cet émetteur ne doit pas être colocalisé ou fonctionner en conjonction avec une autre antenne ou un autre émetteur. communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. Le matériel a été évalué pour répondre aux exigences générales d'exposition aux radiofréquences.Le dispositif peut être utilisé dans des conditions d 'exposition c portables illimitées. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. The device is designed to meet the requirements for exposure to radio waves established by the Innovation, Science and Economic Development Canada's. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use The device has been evaluated to meet general RF exposure requirement. The device can be when properly worn on the body is 0.632 W/kg. L'appareil est con?u pour répondre aux exigences d'exposition aux ondes radio used in portable exposure condition without restriction. établies par l'Innovation, Sciences et Développement économique Canada. Ces exigences fixent une limite DAS de 1.6 W / kg en moyenne sur un gramme de tissu. La valeur DAS D This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF la plus élevée rapportée selon cette norme lors de la certification du produit pour une utilisation lorsqu'il est correctement porté sur le corps est 0.632W/kg. exposure compliance. The device is designed to meet the requirements for exposure to radio waves established by the Federal Communications Commission (USA). These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the body is 0.632 W/kg. E F A3 2 3 4 5 6 7 8Adobe Illustrator 24.1 (Windows) Adobe PDF library 15.00