Instruction Manual for Scandia models including: SG010100032 Sparky Freestanding Electric Fire, SG010100032, Sparky Freestanding Electric Fire, Freestanding Electric Fire, Electric Fire, Fire
Model Sparky Freestanding Electric Fire Rated Power 1900W Rated Voltage 230-240VA 50Hz Appliance Dimensions Height 545 mm Width 430 mm Height 315 mm
Sparky Freestanding Electric Fire | Scandia Wood Fire and Gas Heating
File Info : application/pdf, 12 Pages, 273.14KB
DocumentDocumentSPARKY FREESTANDING ELECTRIC FIRE OPERATION AND INSTALLATION MANUAL Sparky Freestanding Electric Fire SG010100032 Spa Version 1.0.2 19/01/2024 Contents of this manual may be updated without notice. www.scandiastoves.com.au CONTENTS Introduction 3 Important Instructions 4 Specifications 5 Using Your Freestanding Electric Fire 5 Operating Instructions 6 Care and Maintenance 9 Warranty 10 WARNING This appliance must be installed in accordance with: · Manufacturer's Installation Instructions · Current AS/NZS 3000 · Local Regulations and Municipal Building Codes Including local OH&S requirements. For continued safety of this appliance it must be installed and maintained in accordance with the manufacturer's instructions. 2 INTRODUCTION Congratulations on purchasing a genuine Scandia Electric Fire. When cared for properly, these high quality, finely crafted appliances will offer many years of reliable performance. This instruction manual has been developed to ensure optimum performance from your Scandia Electric Fire. It's very important that you thoroughly read and understand all instructions before using your new appliance. UNPACKING THE APPLIANCE Carefully remove the appliance from the box and check all items are present and inspect for any physical damage to the appliance, accessories, power cord and plug. Prior to installing the appliance, test to make sure the appliance operates properly by plugging the power cord into a conveniently located and grounded GPO. Whats Included · Remote Control · Log and coal bed media · Installation Manual 3 IMPORTANT INSTRUCTIONS When using electrical appliances the following precautions should always be followed to reduce the risk of fire, electric shock or injury to persons: 1 Read all instructions before using this appliance. 2 The appliance may be hot when in use. To avoid burning, do not touch hot surfaces. Keep combustible items, such as furniture, pillows, bedding, papers, clothes, and curtains at least 1m from the hot air outlet of the appliance. 3 Extreme caution is necessary when any appliance is used near children or infants. 4 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. 5 Do not use the appliance for other than its intended use. For domestic indoor use only. 6 Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool. 7 If you need to disconnect the appliance, turn controls to off, then remove plug from outlet. 8 Do not inset or allow foreign objects to enter any inlet or outlet vents as this may damage the appliance. 9 To prevent damage to the appliance, do not block air inlets or the heating outlet. 10 Do not operate this appliance using a powerboard or extension leads. 11 Use this appliance only as describes in this manual. Any other use is not recommended by the manufacturer. 12 WARNING: In order to avoid overheating, do not cover the heater. 13 This appliance is not intended for use by persons (including children) with reduced physical, sensory or capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance 14 CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cutout, this appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility. 4 SPECIFICATIONS Model Rated Power Rated Voltage Appliance Dimensions Height Width Height Unit Net Weight Installation Options Power cable length Power cable position Sparky Freestanding Electric Fire 1900W 230-240VA 50Hz 545 mm 430 mm 315 mm 14 KG Freestanding 1.8m Middle rear of appliance USING YOUR FREESTANDING ELECTRIC FIRE Using your new freestanding electric fire is a straightforward process, allowing you the flexibility to place it within most places within your home. Ensure you adhere to the provided general instructions for selecting a suitable location. For optimal flame results, install the freestanding electric fire away from direct sunlight and close to the power supply GPO. 5 OPERATING INSTRUCTIONS MAIN POWER SWITCH Turn on the main power switch, the buzzer beeps once to indicate that the appliance is powering on, then the machine is in a standby state; APPLIANCE WITH CONTROL PANEL The Control Panel is located top right of the appliance behind the removable vent cover: Heater Indicator Wifi Indicator On/Off Switch Heater Flame Timer Indicator FUNCTIONS Flame ICONS Heater Press button to adjust heater and blower DISPLAY N/A OPERATIONS DETAILS Press button to adjust the color of the flame First Press Turn on two group the heating system at 1500W high level Second Press Turn on one group the heating system at 750W low level Third Press Turn off all heating system and blower delay shutdown 6 OPERATING WITH REMOTE CONTROL BUTTON / MAIN FUNCTION Main power Toggle on/off flame and coal bed lights Toggle between Celsius and Fahrenheit Adjust preset temperature Adjust brightness of red, yellow, and blue flame Coal Bed bed lighting Heating Modes (High, Low and OFF) Timer setting DESCRIPTION Power On/ Off Press to turn on or off the flame and coal bed lights Press to change displayed temperature units between Celsius and Fahrenheit Press the arrow to adjust preset temperature Presets:16-19-21-23-25-27-30 Presets:61-66-70-73-77-80-86 Cycle through 4 different brightness modes including Off. Adjust brightness of red,yellow, and blue flames. Cycle through 12 different colors and all colors auto circulation Cycle through 3 heating modes including OFF Cycle through from 30min, 1h, 2h, 3h, 4h, 5h, 6h, 7h, 8h and 9hrs Adjust flame speed Cycle through 3 different flame flicker speeds REMOTE CONTROL SPECIFICATION Make sure your "AAA" batteries (x2) are fully charged and installed correctly in your remote control before operating. The remote control must remain within 6 meters of the appliance to be effective, this range may be reduced when battery power is depleted. 7 WIFI SMARTPHONE AND SMART HOME INSTRUCTIONS Your Scandia Sparky Freestanding Electric Fire can be connected and fully operated using a WiFi Smartphone App, it can also be connected to either a Google Home or Amazon Alexia device for simple on/off operation commands. Please scan the following QR code for detailed instructions on how to connect your Sparky Freestanding Electric Fire using the WiFi Smartphone App, Google Home or Amazon Alexia: 8 CARE AND MAINTENANCE PREPARATION FOR MAINTENANCE ALWAYS DISCONNECT THE POWER AND ALLOW THE ELECTRIC APPLIANCE TO COOL BEFORE PERFORMING ANY CLEANING, MAINTENANCE OR RELOCATION OF THIS ELECTRIC APPLIANCE. TURN CONTROLS TO OFF AND REMOVE PLUG FROM OUTLET OR TURN OFF THE HOUSE CIRCUIT BREAKER TO ELECTRIC APPLIANCE RECEPTACLE. CLEANING NEVER immerse or spray with water. Doing so could result in electric shock, fire, or personal injury. METAL: Wipe using a soft cloth, slightly dampened with a citrus oil based product. DO NOT use brass polish or household cleaners as these products will damage the metal trim. GLASS: Use a good quality glass cleaner sprayed onto a cloth or towel, clean the glass then dry thoroughly with paper towel or a lint-free cloth. NEVER use abrasive cleaners directly on the glass surface. VENTS: Use a vacuum or duster to remove dust or debris from the vent inlet and outlet areas. PLASTIC: Wipe gently with a slightly damp cloth and a mild solution of soap and warm water. NEVER use abrasive cleansers directly on the plastic surface. 9 WARRANTY 2 YEAR LIMITED WARRANTY This limited warranty (Warranty) is given by Scandia Heating (Aust) Pty Ltd (ACN 005 868 093) (Scandia or we) to the original retail purchaser (You) of the Electric Fire to which this Warranty applies. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. The benefits that this Warranty provides are in addition to other rights and remedies available to you under the Australian Consumer Law. This Warranty does not limit those rights and remedies. IMPORTANT: For this Warranty to apply, you must fully complete the online warranty registration form within 30 days after the original purchase. By completing this, you also agree that, to the extent permitted by law, our liability to You on any basis in relation to the Electric Fire (other than under the Australian Consumer Law) is limited to our obligations under this Warranty. SCOPE OF WARRANTY If: · a defect in material or workmanship appears in the following parts within the corresponding warranty period after the date of the original purchase, such as to make the Electric Fire unfit for normal home use and; · you comply with the requirements below regarding making a claim, then, subject to the exclusions below, we will (or will arrange to) replace or repair the relevant part or (at our option) replace the entire Electric Fire with the same or comparable model. EXCLUSIONS This Warranty does not apply: · if the Electric Fire is not installed or operated to the specifications detailed in this manual; · where the defect is not due to the original design or manufacture of the part (including where the appliance or part has been subject to accident, abuse, alteration, misuse or neglect or has been installed, altered, inspected, operated, cleaned or maintained negligently or not in accordance with applicable local laws, regulations and standards and the instructions and requirement included in this manual); · if you are not a retail purchaser, or in the case of non domestic use (e.g. any commercial venue); · to any accessories or optional parts; · to noise caused by minor expansion, contraction or movement of parts; · to any initial smell due to dust, paint or surfaces curing; · to changes in surface finishes as a result of ordinary use (including interior and exterior colour changes or fingerprint marks) or any discolouration of glass; 10 WARRANTY....continued · to any surface rust which may occur in transit, storage or use; · to any defect caused, or likely to have been caused, by an unsuitable environment, including but not limited to: Close proximity to beaches; atmospheres containing chlorine or fluorine. HOW TO MAKE A CLAIM Any claim under this Warranty must be in writing to our mail or email address below. It must be sent within the applicable warranty period and must include: · the model number of the Electric Fire; · A copy of the receipt detailing the place, price and date of purchase; and · reasonable details of the defect. REGISTER YOUR PRODUCT REGISTER ONLINE Register your product warranty online by visiting: www.scandiastoves.com.au/warranty Your data will be used by Scandia to provide you with information about your purchase upon request. 11 Head Office 58 Access Way, Carrum Downs VIC 3201 Australia Scandia Heating (Aust) Pty Ltd (03) 8579 5900 service@scandiastoves.com.au www.scandiastoves.com.au