Residential & Commercial Lighting | Intense Lighting
Instruction Manual for Intense Lighting models including: IHOL-6DS Gravity High Lumen Square Downlight, IHOL-6DS, Gravity High Lumen Square Downlight, Lumen Square Downlight, Square Downlight, Downlight
IMPORTANT SAFETY INSTRUCTIONS Read all installation instructions before installing. It is important to save these instructions. Observe and follow all label information and instructions regarding dry, damp and wet location listings, proper Intense LED module, warnings of installation near combustible materials and/
GD6DS | Products
File Info : application/pdf, 3 Pages, 432.93KB
DocumentDocumentInstallation Instructions Gravity Gravity High Lumen Square Downlight (IHOL-6DS / IHOL-8DS) IS-R1012R4 1 of 3 IMPORTANT SAFETY INSTRUCTIONS Read all installation instructions before installing. It is important to save these instructions. Observe and follow all label information and instructions regarding dry, damp and wet location listings, proper Intense LED module, warnings of installation near combustible materials and/ or insulation. Turn off power at circuit breaker before attempting to install or perform maintenance on the fixtures. Be sure to connect ground wire to prevent electric shock or other potential hazards. The product must be installed in a manner consistent with the intended use and in compliance with the national electrical codes and local codes. Do not block the trim aperture as this may cause unsafe operating conditions. WARNING: RISK OF FIRE. Non-IC fixture requires that insulation must be kept at least 3" away from all sides of the fixture. Minimum of 90°C supply conductors. Consult a qualified electrician before installation. WARNING: Use only Intense Lighting trims listed for use with this fixture. Use of trims other than those listed by Intense Lighting is a violation of N.E.C 110-3(B) and voids all warranties. INSTALLATION INSTRUCTIONS 1. Install fixture into ceiling cavity using universal mounting bracket which has slot openings for C-Channel, flat bar, wood joist bar hanger (ordered separately) and 1/2" EMT (by others). Secure to joist or grid using fasteners or wire. C-Channel hangers are recommended for T-Bar ceilings, install with notches facing down to engage T-Bar grid (Fig. 1). 2. Mounting bracket includes a wing nut to adjust fixture to accommodate different ceiling thickness or ceiling construction (Fig. 2). 3. Remove junction box cover plate. Remove desired knockout, the junction box will accept metal conduit or non-metallic cable. 4. Connect black wire from fixture to black (HOT) supply wire, white wire from fixture to white (NEUTRAL) supply wire and connect the ground from fixture to green (GROUND) supply wire. Use UL listed connectors or wire nuts to make the connections (not included). (Fig. 3). 5. Make connections in junction box and replace cover plate. 6. Squeeze torsion springs on trim and insert into bracket in housing (Fig. 4). 7. Once all fixtures have been installed, power at the breaker can be restored. Fig. 1 C-Channel slots Fig. 2 T-Bar notch Fig. 3 Black Fig. 4 C-Channel Wing nut White Bar Hanger Green Torsion springs Bar hanger slots EMT slot T-Bar notch Bar hanger slots Junction box cover plate INSTRUCTIONS L/M-2022 P-4 INTENSE LIGHTING | 3340 E La Palma Ave, Anaheim, CA 92806 | tel 714 630-9877 | fax 714 630-9883 For Intense Lighting's limited product warranty, go to www.intenselighting.com. For a printed copy of the warranty, you may call 800 961-5321. © 2022 Intense Lighting, LLC. All rights reserved. Note: This document is subject to change without notice. WIRING & DIMMING COMPATIBILITY For use with all Intense Lighting product with supported dimming options. Please check configuration of product for correct dimming protocol. Phase Dimming or Lutron® LTEA2W Hi-Lume 2-Wire 120V Only Forward 1% / Reverse 5% COMPATIBLE DIMMERS Product Part Number(s) Leviton IPE04 Leviton IPI06-1LZ Leviton 6633-P Lutron DVELV300P Lutron DVCL-153P Lutron S600P Cooper DLC03P Cooper DAL06P Type Reverse Forward Forward Reverse Forward Forward Forward Forward 120V INPUT FROM DIMMER Black White Green DRIVER 0-10V Dimming 120V or 277V Dims down to 1% or 0.1% light output Consult dimming manufacturer for installation instructions and power packs COMPATIBLE DIMMERS Manufacturer Part Number(s) HUNT PS-010-IV-120V, PS-010-WH-120V, PS-010-3W-IV-120, PS-010-3W-WH-120V, PS-010-IV-277V, PS-010-WH-277V, PS-010-3W-IV-277V, PS-010-3W-WH-277V, FD-010: PS-IFC-010-IV, PS-IFC-010-WH-120/277V, FD-010: PS-IFC-010-3W-IV, PS-IFC-010-3W-WH-120/277V, FD-010-120V, FD-010-277V Leviton Leviton Centura Fluorescent Control System, IllumaTechTM IP7 Series, DPSPE-212 Lightolier ZP600FAM120, MP1500FAM120, V2000FAMU Lithonia LEQ BC, LEQ LVBC, SLD LVBC, SQ1DC Lutron DVTV, NTFTV Synergy ISD BC 120/277 INPUT Black White Green DRIVER 0-10V DIMMING Violet (+) Grey or Pink (-) Lutron® LDE1 Hi-Lume EcoSystem 120V or 277V Dims down to 1% Consult dimming manufacturer for installation instructions COMPATIBLE DIMMERS Product Part Number(s) EcoSystem CS-1L-WM, CS-2L-WM, CS-1L-CM, CS-2L-CM, EcoSystem ESN, Grafik Eye QS with EcoSystem, Quantum ECOSYSTEM CONTROLS (BY OTHERS) Black White Green DRIVER Violet/White (E1) ECOSYSTEM BUS Violet (E2) DMX512 RDM (Downlights with RJ45) 120V or 277V Dims Down to 0.1% Light Output RDM Channel Programmable 120V or 277V INPUT Black White Green DRIVER Terminal In/Out DMX PORT RJ45 In/Out INSTRUCTIONS L/M-2022 P-5 INTENSE LIGHTING | 3340 E La Palma Ave, Anaheim, CA 92806 | tel 714 630-9877 | fax 714 630-9883 For Intense Lighting's limited product warranty, go to www.intenselighting.com. For a printed copy of the warranty, you may call 800 961-5321. © 2022 Intense Lighting, LLC. All rights reserved. Note: This document is subject to change without notice. IS-R1012R4 2 of 3 Red LED LIGHT Blue ENGINE Red LED LIGHT Blue ENGINE Red LED LIGHT Blue ENGINE Red LED LIGHT Blue ENGINE WIRING & DIMMING COMPATIBILITY For use with all Intense Lighting product with supported dimming options. Please check configuration of product for correct dimming protocol. DMX512 RDM (Cylinders without RJ45) 120V or 277V Dims Down to 0.1% Light Output RDM Channel Programmable 120V or 277V INPUT Black White Green DRIVER DMX512 IN Orange/White (DMX +) Orange (DMX -) Brown (DMX Ground) IS-R1012R4 3 of 3 Red LED LIGHT Blue ENGINE 0-10V With Dynamic Beam 120V or 277V Dims down to 1% or 0.1% light output Consult dimming manufacturer for installation instructions and power packs COMPATIBLE DIMMERS Manufacturer Part Number(s) HUNT PS-010-IV-120V, PS-010-WH-120V, PS-010-3W-IV-120, PS-010-3W-WH-120V, PS-010-IV-277V, PS-010-WH-277V, PS-010-3W-IV-277V, PS-010-3W-WH-277V, FD-010: PS-IFC-010-IV, PS-IFC-010-WH-120/277V, FD-010: PS-IFC-010-3W-IV, PS-IFC-010-3W-WH-120/277V, FD-010-120V, FD-010-277V Leviton Leviton Centura Fluorescent Control System, IllumaTechTM IP7 Series, DPSPE-212 Lightolier ZP600FAM120, MP1500FAM120, V2000FAMU Lithonia LEQ BC, LEQ LVBC, SLD LVBC, SQ1DC Lutron DVTV, NTFTV Synergy ISD BC 120/277 Black INPUT White Green DRIVER Red Blue 0-10V DIMMING Violet (+) Grey or Pink (-) 0-10V BEAM CONTROL Violet/Orange or Violet/White Grey/Orange or Pink/White LED LIGHT ENGINE 0-10V With Tunable White 120V or 277V Dims down to 1% or 0.1% light output Consult dimming manufacturer for installation instructions and power packs COMPATIBLE DIMMERS Manufacturer Part Number(s) HUNT PS-010-IV-120V, PS-010-WH-120V, PS-010-3W-IV-120, PS-010-3W-WH-120V, PS-010-IV-277V, PS-010-WH-277V, PS-010-3W-IV-277V, PS-010-3W-WH-277V, FD-010: PS-IFC-010-IV, PS-IFC-010-WH-120/277V, FD-010: PS-IFC-010-3W-IV, PS-IFC-010-3W-WH-120/277V, FD-010-120V, FD-010-277V Leviton Leviton Centura Fluorescent Control System, IllumaTechTM IP7 Series, DPSPE-212 Lightolier ZP600FAM120, MP1500FAM120, V2000FAMU Lithonia LEQ BC, LEQ LVBC, SLD LVBC, SQ1DC Lutron DVTV, NTFTV Synergy ISD BC 120/277 Black INPUT White Green DRIVER Red Blue 0-10V DIMMING Violet (+) Grey or Pink (-) 0-10V CCT Violet/Orange or Violet/White Grey/Orange or Pink/White LED LIGHT ENGINE DALI With Tunable White 120V or 277V Dims down to 0.1% 120V or 277V INPUT Black White Green DRIVER Orange (DALI DA) Orange/White (DALI DA) Red LED LIGHT Blue ENGINE INSTRUCTIONS L/M-2022 P-6 INTENSE LIGHTING | 3340 E La Palma Ave, Anaheim, CA 92806 | tel 714 630-9877 | fax 714 630-9883 For Intense Lighting's limited product warranty, go to www.intenselighting.com. For a printed copy of the warranty, you may call 800 961-5321. © 2022 Intense Lighting, LLC. All rights reserved. Note: This document is subject to change without notice.