Instruction Manual for Lexicon models including: 194840227984 Janwood Wall-Hugger Power Reclining Chair, 194840227984, Janwood Wall-Hugger Power Reclining Chair, Hugger Power Reclining Chair, Power Reclining Chair, Reclining Chair, Chair
Lexicon Janwood Wall-Hugger Power Reclining Chair, Gray : Home & Kitchen
ASSEMBLY INSTRUCTION ITEM NO: 194840227984 POWER RECLINING CHAIR The plug with wire stored in the bottom of the seat, please take out of assembly. NOTE: Do not use power tools for assembly. Power tools increase the risk of over tightening which leads to splitting or cracking the wood. COMPONENT LIST (CHAIR) NO. DRAWING QTY DESCRIPTION A 1 SEAT B 1 BACK REST PLUG WITH C 1 WIRE PAGE 1 OF 3 STEP# 1 Attach Back Rest (B) to the Seat(A) B A STEP# 2 Attach Plug with Wire(C) to the Power Switch To operate the chair: Make sure the switch is off before you plug/connect the wire. Connect the wire to the switch which locate at the lower back of the seat, plug in to the outlet. Switch on to operate the power chair. Please always turn off the switch and unplug it before you move or switch the chair. Do not modify the electrical parts or use extension cord, improper usage may cause damages or injury. PAGE 2 OF 3 OFF ON POWER SWITCH C STEP# 3 Completed Close Open USB Care Instructi on for Polished Microfiber Furniture. In order to maintain the original appearance of your Polished Microfiber furniture, please follow below simple care procedures: ·Avoid exposing furniture directly to sunlight or heating and air conditioning outlets. Sunlight and/or exposure to heating and air conditioning outlets will fade/damage polished microfiber. ·Do not place your upholstered furniture too close to windows, radiators, or vents and be sure to use window, radiators, or vents. ·Vacuum or wipe with a soft brush to remove dust. ·For items used on wooden floor, hard surfaces or carpets, it is recommended to install protective pads ·under all legs supports to avoid/prevent from damages/ scratches discolora on. Warning Do not allow electrical cord to be pinched between moving parts or between the frame and the floor. Do not place cord under carpet or in location where it could become worn. PAGE 3 OF 3Corel PDF Engine Version 16.1.0.843