Instruction Manual for bsi models including: Built Under Oven Unit, 600, 170805 05
2 Assembly Instructions. 3 Without Drawer. 4 With Drawer. Important Information - True Handleless Kitchens Installers: See Note AboveTH. 154085. 10. 154068.
29 ago 2022 — Caution: Some pieces of hardware could be hazardous to small children. Keep all these items out of reach and do not leave children unattended in the ...
File Info : application/pdf, 2 Pages, 2.17MB
DocumentDocument600 Built Under Oven Unit Assembly TH Note: If fitting a "True Handleless" kitchen, some components will differ to those shown in this instruction and will also be packaged separately. Please refer to your True Handleless guide to Receiving for further details on the different components and difference in installation. Components C A B A D B D Note: Supports D not used if fitting drawer. Important Information - True Handleless Kitchens Installers: See Note Above TH Caution: Some pieces of hardware could be hazardous to small children. Keep all these items out of reach and do not leave children unattended in the assembly area. Please read these instructions carefully before proceeding. Refer to the Guide to Receiving and Installing your Kitchen booklet for further information. Note: Due to variation in wall conditions no screws are supplied for fixing the units to the wall. If in doubt consult an expert. Assemble the unit on a clean solid work surface. In the interest of continuing improvements we reserve the right to amend or adjust the specifications without prior notice. Errors and omissions excepted. These units may be fitted with a drawer system. The drawers are supplied separately. These instructions show the runner positions for the drawer system. Follow the instructions supplied with the drawers for drawerbox assembly. Every effort has been made to ensure that this product leaves the factory in perfect condition. In the unlikely event that an item is damaged or incorrect, please contact the customer services department. FM 665131 Note - Fitting Handles: (1) Decide where you are going to position each handle to maintain symmetry around your kitchen. (2) Measure the handle centres and mark off each door/drawer position. (3) Drill through the door/drawer using a fine drill (<2.5mm), then drill back from the rear face using a 4.5mm drill. (4) Attach with the fixings provided with your handle. Ref. No. 150101 Item 3.5x12mm 150202 150201 4x12mm 4x15mm 150124 154082 4x25mm 154085 Quantity 4 14 22 Ref. No. Item 154068 154047 8 154014 10 154015 10 154004 10 151999 1 2 Assembly Instructions 12 TH Modification required at this stage, see True Handleless guide for further details. Quantity Ref. No. Item Quantity Tools Required 6 152401 4 2 152418 4 2 152402 2 2 150308 2 2 150309 2 3 Without Drawer 5mm Drill Medium Crosshead Screwdriver Large Flathead Screwdriver Spirit Level 4 With Drawer 21 G-Clamp (pair) Hammer Tape Measure Bradawl 619mm 619mm 684mm 619mm A 12 12 12 12 1 1 154082 10 A A 21 21 50mm D 3 3 3 3 Note: Left hand panel shown only, mirror 21 21 for right hand panel. 2 3 2 154004 Note: For ease of fitting, Step 17 can be completed at this point. 3 10 150124 8 A 70mm 4 Drawer runner 4 400mm Note: Left hand panel shown only, mirror for right hand panel. Drawer Runner Front x4 1 x 'L'; 1 x 'R' x2 3.5 x 16mm Fit as third screw 4 4 150202 4 154068 4 5 5 5 5 C B 5 5 5 5 B 5 5 67 5 6 6 TH Modification required at this stage, see True Handleless guide for further details. 5 5 154085 10 A 66 6 C D 6 6 B B 6 6 6A 6 7 Do Not Over Tighten Start Locked 89 8 8 8 8 9 9 9 8 9 8 152401 140mm 45mm 10 14 Installation Instructions 10 4 150201 16 10 11 11 12 8 13 13 12 13 13 10 10 150202 4 154047 2 82mm 11 11 150202 2 154068 2 TH Modification required at this stage, see True Handleless guide for further details. 9 152418 = = 13 4 (Only if Drawer is 4 150202 being fitted) 14 14 13 12 12 150308 2 150309 2 5mm 14 14 152402 2 150101 4 15 16 Without Drawer 15 17 18 Without Drawer 17 154014 2 150201 2 Note: Do not over tighten screws or use a power screwdriver. 154015 2 150201 4 Note: For ease of fitting, Step 17 can be completed at same time as Step 3. 592m5mmm 15 16 TOP 16 59mm 15 25mm 17 32mm 40mm 37mm 19 20 With Drawer 32mm 19 31.5mm 64mm TOP 20 19 20 19 59mm 15 25mm 16 16 151999 2 17 20 17 18 18 20 151199 2 Ref. 170805 (05)