1. Device Overview
The front of the ActionCam v3 features a large 7-inch LCD screen and an integrated RFID antenna. The device is designed for user interface and RFID tag interaction.
Image 1.1 – Front View: Depicts the front of the unit, highlighting the 7" LCD screen and the RFID antenna positioned around the perimeter.
2. Electrical/Power
The device is powered via the RJ45 Ethernet connector. It requires a power supply that meets the PoE 802.3at standard, Type 1, or higher. The maximum power consumption of the unit is 12.95W.
3. PoE/LAN Connection
Power and network connectivity are established through the single RJ45 Ethernet connector. Network configuration, including IP address assignment, should be handled by a DHCP server on the local network. If the device fails to obtain an IP address from the server, a message will be displayed on the screen to alert the user of the lack of network connection. This PoE/LAN connection is the sole operational mode for the unit.
Image 1.2 – Angled Rear View: Shows the rear of the unit, indicating the location of the RJ45 connector which supports both LAN and PoE.
4. Device Operation
When the device is properly configured and connected to the network, it will establish a connection with the host server and display a sequence of images in a loop on its LCD screen. Upon presentation of an RFID ICODE tag in front of the LCD, the device will provide audible feedback (a beep) and display images received from the server as a response. The ActionCam v3 functions as a terminal, presenting messages sent from the server over the Ethernet LAN connection to the user. It also transmits RFID tag information read by the device to the server via the LAN connection and can write information sent from the server to the user's RFID tag.
5. FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, as per part 15 of the FCC Rules. These limits are established to provide reasonable protection against harmful interference in residential installations. The equipment generates, uses, and can radiate radio frequency energy. If not installed and used according to the instructions, it may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a specific installation.
If this equipment causes harmful interference to radio or television reception, which can be identified by turning the equipment off and on, users are encouraged to attempt to correct the interference by implementing one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit that is different from the one to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for assistance.
Caution: Any changes or modifications made to this device that are not explicitly approved by the manufacturer could void the user's authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information: The device has been evaluated to meet general RF exposure requirements and can be used in portable exposure conditions without restriction.
