Instruction Manual for KFI Products models including: 102000, Rear Double Tube Bumper, Tube Bumper, Rear Double Bumper, Bumper
Polaris Ranger Mid-Size Rear Bumper by KFI Products - 102000
KFI Products Double Tube Rear Bumper - 102000 | Polaris Ranger SP 570 2022 | FortNine Canada
POLARIS MIDSIZE RANGER Rear Double Tube Bumper PART #102000 Item # Qty. 1 1 2 1 3 1 4 4 5 1 5.1 2 5.2 4 5.3 6 5.4 12 Kit Components: Description Rear Bumper Bumper Bracket (driver side) Bumper Bracket (passenger side) Bumper Tube Cap Hardware Kit (HK-412) 5/16"-18 x 1.75 Hex Flange Bolt 5/16"-18 x .75 Carriage Bolt 5/16"-18 x .75 Carriage Bolt (black) 5/16"-18 Hex Flange Nylock Nut 5.2 5.4 2 5.1 5.4 5.3 1 3 5.3 Figure 1 4 ©2022 Copyright Kappers Fabricating, Inc. All rights reserved Page 1 INSTALLATION INSTRUCTIONS Note: Make sure all hardware needed to complete this mount is in the package. Thoroughly read through and understand the instructions before installing. Figure 2 1. Assemble bumper tube caps (4) as shown in Figure 1. 2. Remove plastic wire clip (A) on drivers side bed A frame hinge shown in Figure 2. 3. Using an 11/32" drill bit, drill holes (B) on both driver and passenger side bed frame hinges shown in Figure 2. 4. Set bumper brackets (2 & 3) inside of the bed frame hinges and fasten to the hinge using bolts (5.2) and nuts (5.4) as shown in Figure 4. Figure 3 5. Swing brackets (2&3) into position and install to bed frame using bolts (5.1) and nuts (5.3) as shown in Figure 4. NOTE: It may be easier to remove tailgate before installing bolts. 6. Reinstall plastic wire clip (A) removed in step 2. 7. Set rear bumper (1) onto bumper brackets (2 & 3) and secure using bolts (5.3) and nuts (5.4) as shown in Figure 5. 11/32" B 8. Tighten all hardware evenly. Figure 4 Figure 5 1 2 5.1 5.4 5.2 5.4 5.3 5.4 3 1 3 ©2022 Copyright Kappers Fabricating, Inc. All rights reserved Page 2Adobe PDF Library 9.0 Adobe InDesign CS4 (6.0.6)