Instructions for anko models including: 91 cm Animated Light Up Halloween Scary Ghost Decoration Light, Animated Light Up Halloween Scary Ghost Decoration Light, Up Halloween Scary Ghost Decoration Light, Halloween Scary Ghost Decoration Light, Scary Ghost Decoration Light, Ghost Decoration Light, Decoration Light, Light
20 août 2023 — Step 2. Place the long screw and screw nut into correct position through the legs screw hole. Use a screwdriver (not included) to tighten the long screw ...
91cm scary ghost Contents: Instructions Step 1. Insert the upper part body (Part A) to the bottom part (Part B). Step 2. Place the long screw and screw nut into correct position through the legs screw hole. Use a screwdriver (not included) to tighten the long screw into the leg screw hole and screw nut, tighten the screw until the screw is inside the leg hole. Step 3. Pose the Ghost in arms open position. Make sure no excess fabric is on the light sensors. (Refer figure 1) Step 4. The ON/OFF/DEMO switch is located on the back of the upper body. Move the switch to "On" position to place the product into Motion Activated Mode. Step 5. Place the switch into the OFF position and remove the batteries when not in use or when being stored. Warning: -Keep away from fire and direct heat source. -For indoor use only. -This is not a toy children must be supervised when using this decoration. -Do not place in a child's bedroom or playroom. -Battery installation by an adult is required.Microsoft Word for Microsoft 365