ACURA MDX Trailer Hitch Installation
Model: 13354
Towing Capacity
Gross Load Capacity (Weight Carrying Hitch): 4,000 LBS. Trailer Weight & 400 LBS. Tongue Weight.
Gross Load Capacity (Weight Distribution Hitch): 5,000 LBS. Trailer Weight & 500 LBS. Tongue Weight.
DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.
Parts List
| ITEM | QTY | PART NUMBER | DESCRIPTION |
|---|---|---|---|
| 1 | 4 | M14 - 1.5 x 35 HEX | HEX BOLT |
| 2 | 4 | 9/16" CONICAL WASHER | CONICAL TOOTHED WASHER |
| 3 | 4 | M14 - 1.5 x 40 HEX | HEX FLANGE BOLT |
Tools Required
| 3/8" DRIVE RATCHET |
| 22mm - 3/8" DRIVE SOCKET |
| 10mm - 3/8" DRIVE SOCKET |
| TORQUE WRENCH |
Installation Overview
The diagram illustrates the CURT 13354 trailer hitch being attached to the frame rails of an Acura MDX. It shows the passenger side frame rail and the driver side frame rail, with mounting points and hardware.
Parts Identification:
- Item 1: HEX BOLT (M14 - 1.5 x 35)
- Item 2: CONICAL TOOTHED WASHER (9/16")
- Item 3: HEX FLANGE BOLT (M14 - 1.5 x 40)
Mounting Locations: The hitch attaches to existing weld nuts located in both frame rails.
Orientation Diagram for Conical Toothed Washer: This diagram shows the correct placement of the conical toothed washer between the vehicle frame and the hitch side plate, ensuring proper engagement.
Weldnut Cleaning Illustration: This visual guide demonstrates how to clean debris from weld nuts in the frame. It suggests using spray lubricant or compressed air. For stubborn debris, a small wire brush can be used, with caution to avoid damaging the threads.
Directional Indicators: The diagram includes indicators for "FRONT" and "REAR" to orient the viewer.
Hitch Specifications
Hitch Weight: 28 LBS.
Install Time: 30 MINUTES
Installation Notes
- No drilling required.
- Lower the spare tire and exhaust system to facilitate installation.
- Remove and re-install the heat shield as necessary.
Installation Steps
- Remove the muffler hanger to allow the exhaust to drop down. Remove the spare tire and muffler heat shield to ease installation. Note: Retain heat shields and hardware for re-installation.
- Raise the hitch into position between the frame rails and install fasteners as shown in the diagrams.
- Torque all 14mm fasteners to 101 lb-ft.
- Re-install the heat shield and spare tire (if removed), and re-attach the muffler hangers.
Maintenance Reminder
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Warranty Information
Curt Manufacturing Inc. warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective, Curt Manufacturing Inc. may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or consequential loss or damage.
Find more CURT products on their website.
Learn more about trailer hitches and towing.
