Instruction Manual for Hukoro models including: F15151-11I-S, 2F15151-11i-S, F15151-11I-S Outdoor Wall Lantern Sconce, Outdoor Wall Lantern Sconce, Wall Lantern Sconce, Lantern Sconce
17.75 in 1-Light Modern Outdoor Wall Light with Clear Glass and Matte Black Finish(Dust to Dawn sensor included) 848507010050
Hukoro 2F15151-11i-S 732246210676 0732246210676 1008902164
Hukoro F15151-11i-S 732246210669 0732246210669 1009031239
ASSEMBLY INSTRUCTIONS CAUTION ³Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation. ³Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. @ If you need further assistance, please contact us by Email: customersupport@superiordecorinc.com TOOLS REQUIRED Ladder Safety glasses Electrical Phillips tape screwdriver Flat blade screwdriver Pliers Wire strippers HARDWARE INCLUDED Fixture Mounting Unit Screws Mounting Screws Wire Nuts *PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE EXPLODED PARTS INSTALLATION Wire Nuts Screws STEP 1 Unscrew the screws from the mounting unit. Use the mounting screws to attach the mounting unit to the junction box (not included). Junction Box (not included) Mounting Unit Mounting Screws Fixture Bulbs (not included) STEP 2 Make the electrical connection from the junction box (not included) to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw. Then, connect the positive, negative and ground wires with the supplied wire nuts. Secure with electrical tape. Black or Red wire (hot) from the junction box White wire (neutral) from the junction box Bare or Green ground wire from the junction box *Sealing tape (not included) Black wire from the fixture White wire from the fixture Ground wire from the Fixture *Green Ground Screw ASSEMBLY INSTRUCTIONS INSTALLATION STEP 3 Attach the fixture to the mounting unit through screw holes as shown, and secure it with screws. NOTICE: Please use caulk in the back plate and wall mounting surface to prevent water from entering. *junction box (not included) STEP 4 Install bulb (not included)Adobe PDF library 10.01 Adobe Illustrator(R) 16.0