User Manual for LEDLyskilder models including: R1-1, One Key RF Remote Controller, R1-1 One Key RF Remote Controller, RF Remote Controller, Controller
User Manual Ver 1.0.9. Technical Parameters ... Read all instructions carefully before you begin this installation. ... ETSI EN 301 489-1 V2.2.3.
LEDlife rWave rund mini fjernbetjening - 1 sone, inkl. magnetholder, batteri - LEDLyskilder.no
LEDlife rWave rund mini fjärrkontroll - 1 zone, inkl. magnethållare, batteri - LEDMegaStore.se
One-key RF Remote Controller Model No.: R1-1 One-key portable dimmer/Wireless remote 30m distance/CR2032 battery/Magnet stuck fix Features Apply to single color LED controller. Each remote can match one or more receiver. CR2032 battery powered. Operate with LED indicator light. Magnet on the back which can be easily stuck on any metal surfaces. Technical Parameters LVD RED Input and Output Output signal Working voltage Working current Standby current Standby time Remote distance RF(2.4GHz) 3VDC(CR2032) 5mA 2A 2 years 30m(Barrier-free space) Warranty Warranty User Manual Ver 1.0.9 5 years Safety and EMC EMC standard (EMC) Safety standard(LVD) Radio Equipment(RED) Certification ETSI EN 301 489-1 V2.2.3 ETSI EN 301 489-17 V3.2.4 EN 62368-1:2020+A11:2020 ETSI EN 300 328 V2.2.2 CE,EMC,LVD,RED Environment Operation temperature IP rating Ta: -30 OC ~ +55 OC IP20 Mechanical Structures and Installations LED indicator Click to turn on/off, Press and hold 1-6s to increase/ decrease brightness. R1-1 One-key RF Remote Controller 43.00 mm 17.00 mm Back holder with magnet CR2032 Battery 26.50 mm Note: Before the first use, please remove the protective film on the battery. To fix the remote, three options are offered for selection: Option 1: stuck on any metal surfaces directly. Option 2: fix it on the wall with two screws. Option 3: adhere it to the wall with paster. Match Remote Control (two match ways) End user can choose the suitable match/delete ways. Two options are offered for selection: Use the controller's Match key Match: Short press match key, immediately press on/off key on the remote. The LED indicator fast flash a few times means match is successful. Delete: Press and hold match key for 5s to delete all match, The LED indicator fast flash a few times means all matched remotes were deleted. Use Power Restart Match: Switch off the power, then switch on power, repeat again. Immediately short press on/off key 3 times on the remote. The light blinks 3 times means match is successful. . Delete: Switch off the power, then switch on power, repeat again. Immediately short press on/off key 5 times on the remote. The light blinks 5 times means all matched remotes were deleted. Safety information 1. Read all instructions carefully before you begin this installation. 2. When installing batter y, pay attention to the batter y positive and negative polarity. A long time without the remote control, remove the batter y. When remote distance becomes smaller and insensitive, replace the batter y. 3. If no response from the receiver, please re-match the remote. 4. Gently handle remote, beware of falling. 5. For indoor and dr y location use only.Corel PDF Engine Version 16.1.0.843 CorelDRAW X6