Installation Guide for Rehabmart models including: Clamp Installation Examples, Clamp Installation Examples, Installation Examples, Examples
Playground Tic-Tac-Toe Panel for Swing Sets
Post Installation STEP: 1 DO NOT CEMENT POSTS INTO PLACE UNTIL THE ENTIRE STRUCTURE IS ASSEMBLED. Refer to the General Installation guide footing information and dig proper holes for the support posts. 10859 E Washington Street, Ste. 200 Indianapolis, IN 46229 Page 1 of 1 (Post Installation) Created By: Aaron Price Date: 04/26/2018 3.5-Inch Clamp Installation Examples The following three pages will include examples of how to install some of the most common types of Clamps that are present on our structures that use 3.5-Inch outside diameter posts. The structure that you are assembling might not require all the types of clamps listed in these examples. The Install Guides for specific components that come later in this document might call for a specific type of clamp (a tube clamp for example), those sections will not include detailed instructions for the clamps and should direct you back to this section for more detailed information. 3.5-Inch Flat Clamp Install Example Connect half of the flat clamp to the component using one (1) M8*40 bolt. Then, using the other half of the flat clamp and the hardware provided in the clamp hardware bag, attach the backside of the flat clamp around the post. 10859 E Washington Street, Ste. 200 Indianapolis, IN 46229 Created By: Derick H Date: 11/01/2018 Page 1 of 3 (3.5-inch Clamp Installation Examples) 3.5-inch Clamp Installation Examples 3.5-Inch Tube Clamp Install Example Connect half of the clamp to the component using one (1) M8*30 bolt. Then, using the other half of the tube clamp and the hardware provided in the clamp hardware bag, attach the backside of the tube clamp around the post. 3.5-Inch 90-Degree Flat Clamp Install Example Connect half of the flat clamp to one panel using one (1) M8*40 bolt. Then, using the other half of the flat clamp and the hardware provided in the clamp hardware bag, attach the other half of the tube clamp around the post. Then, attach the next panel to the other side of the clamp using the same process. 10859 E Washington Street, Ste. 200 Indianapolis, IN 46229 Created By: Derick H Date: 11/01/2018 Page 2 of 3 (3.5-inch Clamp Installation Examples) 3.5-inch Clamp Installation Examples 3.5-Inch Double Slide Clamp Install Example Connect half of the double slide clamp to the double slide hood using one (1) M8*30 bolt. Then, using the other half of the clamp and the hardware provided in the clamp hardware bag, attach the backside of the double slide clamp around the post. 10859 E Washington Street, Ste. 200 Indianapolis, IN 46229 Created By: Derick H Date: 11/01/2018 Page 3 of 3 (3.5-inch Clamp Installation Examples) Tic Tac Toe Panel Installation STEP: 1 Attach the Tic Tac Toe Panel to the designated posts using two (2) flat clamps for the top of the panel, and two (2) tube clamps for the bottom of the panel. 10859 E Washington Street, Ste. 200 Indianapolis, IN 46229 Created By: Derick H Date: 10/24/2018 Page 1 of 1 (Tic Tac Toe Panel Installation)Adobe Acrobat Pro DC (32-bit) 21.5.20058