User Manual for Tstudy models including: TD-801, TD801, 2AWU9-TD-801, 2AWU9TD801, TD-801 Dot Matrix Digital Pen, TD-801, Dot Matrix Digital Pen
Tstudy China Corporation Limited TD-801 Dot matrix digital pen 2AWU9-TD-801 2AWU9TD801 td 801
File Info : application/pdf, 3 Pages, 213.00KB
DocumentDocumentUser manual Dot matrix digital pen TD-801 Press the Dot matrix pen power button or press the induction pen tip, the pointer end indicator lights up, and the Dot matrix pen enters the power-on state. If the indicator light does not go on or the yellow light flashes, please charge the Dot matrix pen first. After the battery is fully charged (about 2 hours), it will be turned on for use. Specification Weight 24.5g Dimension 154.2*11.2*11.2 mm Input Charging Time Wireless 3.7V / 250mAH by battery <2Hours BT 4.2 Standby Time Working Time Transmission 50days >6 Hours 15meters 1 / 3 Dimension 67.2mm*2.3mm of Pen Refill distance System Windows7 and above Indicator state: Display State constantly light Waiting for BT connecting or finishing charging constantly blue Connecting flash yellow Low power wanning constantly yellow Charging constantly red abnormal state constantly red Memory full FCC NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that 2 / 3 interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 3 / 3