Owner's Manual for Razor models including: W25173804030, W25173804079, W25173804030 Ground Force Elite Motor And Chain Tensioner, W25173804030, Ground Force Elite Motor And Chain Tensioner, Elite Motor And Chain Tensioner, Chain Tensioner, Tensioner

GROUND FORCE ELITE MOTOR AND CHAIN TENSIONER REPLACEMENT INSTRUCTIONS

PDF/UA

Ground Force Elite - Motor & Chain Tensioner Replacement

Ground Force - Support - Razor

[PDF] ground force elite motor and chain tensioner replacement ... - Razor

Using a 4 mm Allen wrench and 10 mm open wrench, loosen and remove the four (4) bolts that hold the motor and chain tensioner bracket onto the frame.

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized
• Document:
  • References

File Info : application/pdf, 2 Pages, 200.26KB

Required Tools: (Not included)
A. 4 mm Allen wrench B. Phillips screwdriver C. 10 mm open wrench

GROUND FORCE ELITE MOTOR AND CHAIN TENSIONER REPLACEMENT INSTRUCTIONS
MOTOR - PART # W25173804030 CHAIN TENSIONER - PART # W25173804079

WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.

Step 1
Using a 4 mm Allen wrench, loosen and remove the four (4) hex bolts that hold the battery cover. Place your finger under the bolt to prevent the lock nut from falling out of place. Save bolts and lock nuts for re-installation.

Step 2
Lift and remove the battery cover being careful not to pull the wires from the power switch and charger port. Locate and disconnect the motor from the controller.

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time. 1

Step 3
Using a Phillips screwdriver, remove the screw that holds the motor cables to the frame.

Step 4
Using a 4 mm Allen wrench and 10 mm open wrench, loosen and remove the four (4) bolts that hold the motor and chain tensioner bracket onto the frame.

Step 5
Motor and chain tensioner bracket are held by lock nuts at the bottom. Once you remove the bolt and lock nuts, tilt the motor and dismount the chain from the motor sprocket. Remove motor and chain tensioner bracket.

Step 6
To install new motor and chain tensioner, reverse steps 1-5.
ATTENTION: Charge battery 12 hours before using.

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time. 2



References