User Manual for POWERQI models including: LC10C, 2AFP2LC10C, LC10 Fast Wireless Charger, LC10, Fast Wireless Charger
Shenzhen Powerqi Technology Co., Ltd. LC10C Fast Wireless Charger 2AFP2LC10C 2AFP2LC10C lc10c
LC10 90*65mm 1:1 / 128g 2020.11.17 Fast Wireless Charger User Manual Thanks for choosing us This is a smart phone wireless charger that allows you enjoy the fun of digital products easily. Please kindly read the user manual before using and keep it for future reference. Connect to Power Adapter Charging Mode Specification Input: DC5V 3A, DC9V 2.22A, DC12V 1.67A Charging distance: 10mm Output: 5W/7.5W/10W/15W Conversion: 72% Frequency: 115205 KHz NW.: 50g Dimension: 58.6×7.3mm Connect the power adapter to socket. Connect adapter to the Type-C interface. *20W PD wall charger need to buy separately, please use the connector adapter accordding to your wall charger USB output port. Make sure the wireless charger dock connect to the power supply. Put the magnetic wireless charging phone one the charger, they will align automaticly. The device also support wireless charging to other nonmagnatic wireless charging function device. FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC RF exposure statement: The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. During the operation of device a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected. FCC ID2AFP2LC10CAdobe PDF library 15.00 Adobe Illustrator(R) 17.0