Hyundai Genuine Accessories: Cargo Blocks

Instructional Symbols / Definitions

• ⚠️ Denotes warnings that may lead to serious physical injury or vehicle damage.
• ❗ Denotes cautions to be taken to avoid physical injury or electronic component damage.
• ⬇️ Denotes cautions to be taken to avoid vehicle and component damage.
• ✔️ Denotes quality processes to be checked prior to moving to the next step.
• ⚙️ Denotes specific tools that are necessary to complete a step.
• ? Denotes important information to be reviewed during the step.
• ? Personal Protective Equipment (PPE): Glasses
• ? Personal Protective Equipment (PPE): Gloves
• ? Personal Protective Equipment (PPE): Mask
• ? Personal Protective Equipment (PPE): Hearing Protection

Basic Required Tools

None

Part Weight (Gross): 0.40 lbs / 0.18 kg

FMVSS 110 Compliance Information

Dealers must ensure that the added weight of options or accessories does not exceed the lesser of 1.5% of GVWR or 100 lbs. If the threshold is exceeded, a "Load Carrying Capacity Reduced" label must be installed, with the reduced capacity written by hand. Load Label Part Number: NP070-09003.

Notes to the Installer

1. Read the entire Installation Instructions before beginning.
2. Scan the barcode label on the accessory part or packaging prior to installation, if applicable. Register the removal of the old part before registering the new part if it's a replacement.
3. Ensure the vehicle is completely clean and dry in the installation area.
4. Properly protect the vehicle in the installation area.
5. Never place tools on painted surfaces, seating surfaces, dash pad, console, or floor carpet/mats.
6. Always wear appropriate personal protective equipment, including gloves and safety glasses, when required.

Kit Overview

*Note: Item 2 is not included in PIO kit.

Installation Steps

New Vehicle Installation

1. Step 1: Open the rear hatch. Remove the Cargo Blocks from the packaging.
2. Step 2: Place Cargo Blocks on the floor in a one (1) foot square shape, with bottoms facing each other as shown. This is the recommended position for demonstrating this accessory.

For Customers

1. Step 1: Open the rear hatch. This product is intended for use on carpeted surfaces only. Place Cargo Block(s) on the vehicle floor hook side down surrounding the cargo to be restrained. Ensure the weight of the item is on the block face. NOTE: Insufficient weight on the block face may result in unstable Cargo Block(s). Ensure the Cargo Block(s) are properly positioned against the cargo.
2. Step 2: To move Cargo Block(s): Remove any weight or items on top. Lift up vertically until the block has disengaged with the floor. Reposition as needed.

WARNING: Unstable cargo could become unbalanced during driving. Place cargo in the most stable position before driving. Cargo is most secure when its weight (Max 15 lbs) and center of gravity are lowest to the ground.

WARNING: Cargo Blocks(s) will not restrain cargo during heavy braking or accident. Unrestrained cargo can cause injury.

Care & Cleaning

The Cargo Blocks can be wiped, swept, lightly vacuumed, cleaned with water, or soap and water. Do not use petroleum-based solvents for cleaning. Ensure the Cargo Blocks are completely dry before placing them in the vehicle.

Application Chart

This chart details accessory compatibility for various Hyundai models.

* Carpet side facing up only