User Guide for FOXTECH models including: H-Wing PRO Vtol Dual Camera Mapping Combo
H-Wing PRO Quick Start Guide V2.1 2021.6 1 /Charging the Battery type-C Please connect your charger with a type-C data cable to charge the remote control. 2 /Assemble the drone 3 /Attaching the Propellers A- A-Tighten counterclockwise. H-wing Black nut propeller A Aircraft head direction B Marked B- B-Tighten clockwise. Unmarked White nut propeller B A 4 / Open and close the remote control,Install the battery / Long press to start/shut down. 5 /Remote Controller Flight mode switch Left Stick Flight attitude switch Right Stick One-click return home 6 / Controlling the drone American hand rotor mode American hand fixed wing model / / Up/Down Turn Left/Right / Forward/ Backward / Turn Left/ Right / Speed Up/ Slow down Useless / Fall/Rise / Roll Left/ Roll Right 7 / Enter position mode In an open outdoor environment, move the remote control to the left and wait for the aircraft to enter the position mode. Altitude mode Altitude mode Position mode 8 / How to unlock(US hand) After entering the position mode, the throttle stick is the lowest and the heading stick is the rightmost to unlock the aircraft. After the motor rotates, please release the joystick immediately. Al titude Rotor Locked connected 20 Airspeed0.0m/sFlyingspeed 0.0m/sAltitude 9 / Rotor switch fixed wing mode Altitude Rotor Locked connect ed 20 100% 0.51 17.4V Raise Level ground Altitude connected 1R0o0t%or Locked 20 0.5 1 17 .4V Airspeed0.0m/s Flying speed 0.0m/s Altitude 0.0m distance 0.0m/sFlight time00:00 30 A When operating the aircraft in rotor mode, you can press the remote control A button to switch to fixed wing mode when you reach 30 meters altitude. Altitude Rotor cked 0.51 connect ed .4V 17 Airspeed0.0m/s Flying speed 0.0m A Pressthe A button on the remote control again to switch to the rotor mode. Altitude Rotor Locked 20 1on0n%e0c t ed Airspeed0.0m/s Flying speed 0.0m/s Altitude 0.0m/sHome tance 0.0 m/sFlight time0 0:0 0 Landing Level ground 10 / How to lock (US hands) After the aircraft lands on flat ground, hit the throttle stick to the lowest position and hold it for a few seconds before the motor stops. Altitude Rotor Locked connected 0 0.51 100% 17.4V 11 / Disconnect the power FCC Warning 15.19 Labeling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be operated with minimum distance 20cm from the body. IC Warning This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. This equipment should be operated with minimum distance 20cm from the body. CE Warning 1. Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. 2. The operating temperature of the device can't exceed 40 and shouldn't be lower than -20 . 3. The device complies with RF specifications when the device used at 20cm from the body. Hereby, Shenzhen HEQ Intelligent Technology Co. LTD. declares that this product is in compliance with essential requirements and other relevant provisions of Directive 2014/53/EU. This product is allowed to be used in all EU member states.WPS 文字