OlimpiaSplendidUS – Portable Air Conditioners, Without Outdoor Unit
User Manual for OLIMPIA SPLENDID models including: B0919 Maestro Pro Inverter, B0919, Maestro Pro Inverter, Pro Inverter, Inverter
Literature Library – OlimpiaSplendidUS
Male. Female. Remove condensate pump assembly from the drain pan for access to route heating cable though pan. Remove these two screws and entire assembly lifts out Route the cable though the small opening in the drain pan on the lower left side of the coil. And pull aprrox. 10” of cable out the front side of the unit.
Remove the bottom pull out tray and bar below supply air to get access to the final 6 screws to remove the cover. 2. 1. 26. Removing the front cover. 27. Page 3 ...
File Info : application/pdf, 14 Pages, 7.61MB
DocumentDocumentTechnical Service Letter MAESTRO Smart 9 HP (Model # 02216) B0919 Pan Heating Cable For Technical Support contact: Lucas Holleron l.holleron@olimpiasplendidusa.com (800) 408-5196 (ext. 103) Removing the front cover To remove the front cover from the unit start by removing the back shoulder section by prying up to get access to the screws underneath. Remove the 2 screws one left and one right to remove the front shoulder piece. Remove the bottom pull out tray and bar below supply air to get access to the final 6 screws to remove the cover. 26 27 1 2 olimpiasplendid.com With the eight screws removed the cabinet is now free to be removed by sliding straight out With the cabinet removed now is a good time to remove the front right access panel for access to the front side of the coil. You will need this access later in the install. olimpiasplendid.com Rotate the unit to get access to the backside and remove the large panel on the back. This will give you access to the condensate pump and the back side of the coil Locate the thermal actuator remove drain line and disconnect wires from actuator Plug in the female connectors on the B0919 on to the thermal actuator and route the cable up though the rubber grommet and Male connect the wires that were removed from the actuator to the male connectors on the B0919 and tuck away inside the chase. olimpiasplendid.com Female olimpiasplendid.com Remove condensate pump assembly from the drain pan for access to route heating cable though pan Remove these two screws and entire assembly lifts out Route the cable though the small opening in the drain pan on the lower left side of the coil. And pull aprrox. 10" of cable out the front side of the unit. olimpiasplendid.com Feed cable under coil support and secure it in place with supplied clips. olimpiasplendid.com Go to the back side of the unit and secure cable with a clip as shown and route the rest of the cable under the condensate pump assembly as shown. Reinstall pump making sure the cable does not interfere with the float switches. Install fixing bracket as shown to keep cable in place olimpiasplendid.com Reinstall drain line on top of the actuator and secure any loose wires or tubes. Repeat slides 2-4 in reverse to reassemble cabinet. The heating cable will now be powered when the unit is in Heating mode olimpiasplendid.com olimpiasplendid.com olimpiasplendid.com