Altronix Home
Installation Guide for Altronix models including: T2PXK7F8, T2PXK7F8D, T2PXK7F8 8 Door Kit with Fused Outputs, T2PXK7F8, 8 Door Kit with Fused Outputs, Fused Outputs, Outputs, Outputs
Altronix T2PXK7F8 | 8-Door Access and Power Integration Kit
File Info : application/pdf, 4 Pages, 737.53KB
DocumentDocumentAccess & Power Integration Altronix/Paxton Kits Models Include: T2PXK7F8 8 Door Kit with Fused Outputs Fully assembled kit includes: - Trove2 enclosure with TPX2 Altronix/Paxton backplane - One (1) eFlow104NB - Power Supply/Charger - One (1) ACM8 - Fused Access Power Controller - One (1) VR6 - Voltage Regulator - One (1) PDS8 - Dual Input Fused Power Distribution Module T2PXK7F8D 8 Door Kit with PTC Outputs Fully assembled kit includes: - Trove2 enclosure with TPX2 Altronix/Paxton backplane - One (1) eFlow104NB - Power Supply/Charger - One (1) ACM8CB - PTC Access Power Controller - One (1) VR6 - Voltage Regulator - One (1) PDS8CB - Dual Input PTC Power Distribution Module All components of these Trove kits are UL Listed sub-assemblies. Please refer to the included corresponding Sub-Assembly Installation Guides for further information. Installation Guide All registered trademarks are property of their respective owners. More than just power.TM Rev. TPXK_050521 Installing Company: _________________________ Service Rep. Name: __________________________________________ Address: _________________________________________________________ Phone #: _________________________ Overview: Altronix Trove Paxton kits are pre-assembled and consist of Trove2PX2 enclosure/backplane with factory installed Altronix power supply/charger and sub-assemblies. They also accommodate up to eight (8) Paxton Net2 Plus modules for up to eight (8) doors in a single enclosure. 120VAC 60Hz Input Current (A) Power Supply Board Input Fuse Rating Power Supply Board Battery Fuse Rating Output Range (VDC) Output Range (VDC) Class 2 Rated PowerLimited Outputs Fail-Safe/Fail-Secure or Dry Form "C" Outputs Additional Fuse or PTC Protected Outputs ACM8(CB) Board Input Fuse Rating ACM8 Board Output Fuse Rating ACM8CB Board Output PTC Rating PDS8 Board Input Fuse Rating PDS8 Board Output Fuse Rating PDS8CB Board Input PTC Rating PDS8CB Board Output PTC Rating Altronix Model Number T2PXK7F8 T2PXK7F8D Configuration Chart: Nominal DC Output Voltage Maximum Supply [DC] [Aux] Current for Main and Aux. Outputs on Power Supply board and ACM8(CB) Access Power Controller's outputs 4.5 6.3A/ 15A/ 250V 32V 24VDC @ 9.7A 20.17- 20.2826.4 26.4 P 8 8 8 10A/ 2.5A/ 250V 250V 10A/ 3A/ 32V 32V 8 10A/ 250V 2.5A 9A 2.5A Installation Instructions: Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and with all local codes and authorities having jurisdiction. Product is intended for indoor use only. 1. Remove backplane from enclosure. Do not discard hardware. 2. Mark and predrill holes in the wall to line up with the top three keyholes in the enclosure. Install three upper fasteners and screws in the wall with the screw heads protruding. Place the enclosure's upper keyholes over the three upper screws; level and secure. Mark the position of the lower three holes. Remove the enclosure. Drill the lower holes and install the three fasteners. Place the enclosure's upper keyholes over the three upper screws. Install the three lower screws and make sure to tighten all screws. Fig. 1 3. Mount included UL Listed tamper switch (Altronix Model TS112 or equivalent) in desired location, opposite hinge. Slide the tamper switch bracket onto the edge of the enclosure, approximately 2" from the right side (Fig. 1, pg. 2). Enclosure Connect tamper switch wiring to the Access Control Panel input or the appropriate UL Listed reporting device. To activate alarm signal open the door of the enclosure. 4. Mount Paxton Net2 Plus modules to TPX2 backplane, refer to page 3. Edge of Enclosure 5. Refer to the eFlow Power Supply/Charger Installation Guide for eFlow104NB and Tamper Switch corresponding Sub-Assembly Installation Guides for the following models: (included) ACM8(CB), PDS8(CB) and VR6 for further installation instructions. To Access Control Panel or Hardware: UL Listed Reporting Device Nylon Spacer | 5/16" Pan Head Screw | Lock Nut - 2 - Trove PX Kits Installation Guide Configuration of Paxton Net2 Plus Modules: 1. Align the Paxton Net2 Plus modules on the backplane to match the modules' mounting holes with corresponding pems. 2. Fasten spacers (provided) onto metal pems (Fig. 2a, pg. 3). 3. Mount Paxton Net2 Plus modules to spacers utilizing pan head screws (provided) (Fig. 2a, pg. 3). Note: Paxton Net2 Plus modules have one (1) RJ45 jack and one (1) switch each. Please make sure that they are mounted correctly, as shown in Fig. 2 below. 4. Fasten TPX2 backplane to Trove2 enclosure utilizing hardware (provided). Fig. 2 L G N Altronix eFlow104NB Paxton Net2 Plus Switch RJ45 Jack Paxton Net2 Plus Switch RJ45 Jack FACP BAT + DC + -+-+ Power Control Paxton Net2 Plus Switch MAIN 10A 250V INTERFACE NO C NC +INP- T + RET- 1234 1234 ON OUTPUT 5 OUTPUT 6 OUTPUT 7 OUTPUT 8 NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM FACP TRG ON TRIGGER INPUT 8 7 6 OUTPUT 1 OUTPUT 2 OUTPUT 3 OUTPUT 4 5 IN GND IN GND IN GND IN GND IN GND IN GND IN GND IN GND Altronix ACM8(CB) RJ45 Jack Paxton Net2 Plus Switch 4 3 2 1 RJ45 Jack + INP1 -- + INP2 -- DM1 + OFF IN1 IN2 DM1 + Altronix PDS8(CB) P Common (--- ) OUT1 DM2 + N 1 OUT2 OUT3 OUT4 OUT5 OUT6 OUT7 2 3 4 5 6 7 Common Power Outputs (NEG) OUT8 8 Common (--- ) DM2 + Altronix VR6 is mounted under PDS8(CB) Paxton Net2 Plus Switch RJ45 Jack Trove PX Kits Installation Guide Paxton Net2 Plus Switch RJ45 Jack Paxton Net2 Plus Switch RJ45 Jack Paxton Net2 Plus Switch RJ45 Jack Fig. 2a Pan Head Screw Pem Spacer Paxton Net2 Plus Backplane - 3 - 2.00" (50.8mm) 1.25" (31.8mm) 6.25" (158.8mm) 1.25" (31.8mm) 1.5" (38.1mm) Enclosure Dimensions (H x W x D approximate): 27.25" x 21.5" x 6.5" (692.15mm x 546.1mm x 165.1mm) 21.50" (546.1mm) 5.25" (133.35mm) 3.5"(88.9mm) 3.5"(88.9mm) 5.25" (133.35mm) 2.00" (50.8mm) 6.25" (158.8mm) 0.5625" (14.3mm) 0.685" (17.4mm) 1.77" (45mm) Knockouts 1.125" (28.3mm) 2.415" (61.3mm) 0.885" (22.5mm) 19.80" (502.9mm) 2.00" (50.8mm) 6.75" (171.5mm) 8.25" (209.5mm) 27" (685.8mm) 8.00" (203.2mm) 1.00" (25.4mm) 0.85" (21.6mm) 1.25" (31.8mm) 2.00" (50.8mm) 2.00" (50.8mm) 5.25" (133.4mm) 7.00" (177.8mm) 5.25" (133.4mm) 1.25" (31.8mm) 2.00" (50.8mm) Altronix is not responsible for any typographical errors. 140 58th Street, Brooklyn, New York 11220 USA | phone: 718-567-8181 | fax: 718-567-9056 web site: www.altronix.com | e-mail: info@altronix.com | Lifetime Warranty IITrove PX Kits E05U MEMBER - 4 - Trove PX Kits Installation Guide