User Guide for MiBOXER models including: FUT041, Single Color LED Strip Controller
This controller adopt the widely used 433MHz wireless technology with the features of low power consumption, long signal transmitting and strong ...
This controller adopt the widely used 433MHz wireless technology with the features of low power consumption, long signal transmitting and strong anti-interference, etc. Widely
Subordinate New Brand Single Color LED Strip Controller (433MHz ) Model No.: FUT041 Features This controller adopt the widely used 433MHz wireless technology with the features of low power consumption, long signal transmitting and strong anti-interference, etc. Widely used on the controlling of hotel lighting and home lighting. Dimmable control 433MHz RF wireless transmission technology Remote control Control distance 30m Input 1 (DC 5.5*2.1mm ) Pilot lamp Input 2 114mm 119mm 37.5mm 22mm 55.5mm 22mm Parameters Remote Control Working Voltage: 3V(2*AAA Battery) Working Temp.: -20~60°C RF: 433MHz Standby Power: 20uA Transmitting Power: <10mW Modulation Method: ASK Control Distance: 30m Strip Controller Input Voltage: DC12V~24V Output: 12A/Channel Total Output: Max 12A Working Temp.: -20~60°C RF: 433MHz Control Distance: 30m Output Connection: Common anode Products Key Diagram Medium brightness ON OFF Maximum brightness Minimum brightness Dimming ring Lowest Highest Connect diagram Pilot lamp instruction: Always lighting means working normally; Flash means receiving remote signal. V- V+ Input: DC12V/24V Single Color LED Strip Controller (433MHz) Model No.: FUT041 Input Voltage: DC12V~24V Output: 12A/Channel Total Output: Max 12A Working Temp.: -20~60°C RF: 433MHz Controlling Distance: 30m Made in China OUTPUT W V+ V+ W Note Factory setting is one remote control one receiver. Users can group it as per the need. One remote can control countless receivers,but one receiver just can bel controlled by max 4 remotes. Linking the controller Power Supply controller Link/Unlink button ON OFF + + W Switch off the light, after 10 seconds switch on again. When the light on, short press " " 1 time within 3 seconds. The light blink 3 times slowly means the linking is done successfully. If the light not blink slowly, the linking failed, Pls switch off the light again, and follow the above steps again. Unlinking the controller Power Supply controller Link/Unlink button ON OFF W Switch off the light, after 10 seconds switch on again. When the light on, short press " " 5 times within 3 seconds. The light blinking 6 times quickly, means the unlinking successfully. If the light not blink quickly, the unlink failed, pls switch off the light again, and follow the above steps to unlink again. Attention 1. Please check whether the input voltage of the constant voltage power supply is in accordance with the controller, and please check the connection of both the cathode and anode, otherwise the controller will be damage. 2. Please don't connect wires with power on. Please turn on again only when it is in right connection and no short circuit. 3. Non-professional user cannot dismantle the controller directly, otherwise it may damage the controller. 4. Please do not use the controller in the place with widely range metal area or strong electromagnetic wave nearby, otherwise, the remote distance will be seriously affected. Made in ChinaAdobe PDF library 15.00 Adobe Illustrator CC 22.1 (Windows)