Commercial Foodservice & Kitchen Equipment | Vollrath Foodservice
Instruction Manual for VOLLRATH models including: 15060, 15060 Untitled Redco Instacut Dicer Chopper, 15060, Untitled Redco Instacut Dicer Chopper, Redco Instacut Dicer Chopper, Instacut Dicer Chopper, Dicer Chopper, Chopper
Vollrath 15060 Pièces détachées et Manuels | Parts Town Canada
File Info : application/pdf, 1 Pages, 787.03KB
DocumentDocumentInstallation Instructions Redco® InstacutTM 3.5 Blade Replacement WARNING Sharp Blade Hazard Blades are sharp and can cause cuts and amputation. To avoid injury from sharp blades, handle with caution. Only trained personal should operate equipment or preform maintenance. Wash new blades with warm, soapy water and rinse thoroughly to remove the thin protective oil film. Keep the sharp edge away from you when handling blades. 1. Remove the pusher head assembly: Tabletop models: Slide the pusher head off the rod guides. Wall mount models: Remove the locking pin (J). Lift handle and slide the pusher head off the guide rods. Place pin back into the hole on the handle assembly to prevent loss. 2. Raise the bumpers approximately 2" (5.0 cm). 3. Loosen thumbscrew and carefully remove the blade assembly. Remove the cutting blade assembly by pressing upwards on the bottom of the side of the blade holder, where the thumbscrew is located. Discard the old blade assembly. 4. Install the new cutting blade assembly by inserting the tab on the blade holder into the groove in the base, then lowering the blade holder into the seated and flush position in the base. Tighten the thumbscrew. 5. Slide bumpers down guide rods to contact base assembly. Position pusher head assembly onto the guide rods, slowly lower pusher head assembly, and check pusher head block to blade alignment. 6. Lubricate the guide bar with mineral oil or Petrol-Gel after each use. Do not use cooking oil as it will become sticky and may permanently damage the equipment. B A B C F D J G C F D E G F H A I Table Top Model E E H F I Wall Mount Model A Guide Rods. Guides and align the pusher head onto the blade set. F Thumbscrew. Used to secure the pusher head block or the blade assembly. B Handle. Used to lower and raise the pusher head block G Pusher Head Bock. Pushes the food product through the blade set. Specifically sized to match the corresponding blade assembly. C Guides. Used for smooth and consistent operation of pusher head H Blade Assembly. Houses the blades. Specifically sized to match the on the guide rods corresponding pusher head block D Pusher Head Assembly. Made up of the pusher head block (and I Base Assembly. Holds the guide rods and blade assembly. "T" handle for tabletop models). E Bumpers. Cushions the stop of the pusher head. J Locking Pin. Secures the pusher head to the handle. www.vollrath.com The Vollrath Company, L.L.C. 1236 North 18th Street Sheboygan, WI 53081-3201 U.S.A. Main Tel: 800.624.2051 or 920.457.4851 Main Fax: 800.752.5620 or 920.459.6573 Customer Service: 800.628.0830 Canada Customer Service: 800.695.8560 Technical Services techservicereps@vollrathco.com Induction Products: 800.825.6036 Countertop Warming Products: 800.354.1970 All Other Products: 800.628.0832 © 2016 The Vollrath Company L.L.C. Part No. 2350079-1 en 1/22/16