Instruction Manual for Cloudy Bay models including: CBSHL125BLORBH, 2A4FVCBSHL125BLORBH, CBSHL125BLORBH Low Voltage Smart Hardscape Paver Light, Low Voltage Smart Hardscape Paver Light

CBSHLXYSWBR-6PK安装说明书-3-09-2022

steve

User Manual

Cloudy Bay Lighting Supply Inc CBSHL125BLORBH Low voltage smart hardscape paver light 2A4FVCBSHL125BLORBH 2A4FVCBSHL125BLORBH cbshl125blorbh


File Info : application/pdf, 5 Pages, 5.54MB

PDF preview unavailable. Download the PDF instead.

GetApplicationAttachment.html?id=6058645
ORBH

4
Thank you for purchasing CloudyBay Smart Lighting fixtures

Low Volt age Smart Hardscape Paver Light Model:CBSHL125BLORBH

4.4inch
Low Voltage Bluetooth Controller

x8
Light Unit

7inch
Low Voltage Bluetooth Controller

x8
Light Unit

JODI

x2 Extension Cord

Wire Nut

x8+10

x8+10

Expansion Pipe ø6x1"

Screw st4.2x1"

x8
Cable clamp st4.2x1"

JODI

x2
Extension Cord

Wire Nut

x8+10 x8+10

Expansion Pipe ø6x1"

Screw st4.2x1"

x8
Cable clamp st4.2x1"

ORBH
12inch
Low Voltage Bluetooth Controller

4
JODI

x8
Light Unit

x2
Extension Cord

Wire Nut

x8+10
Expansion Pipe ø6x1"

x8+10

x8

Screw

Cable clamp

st4.2x1" Y
 st4.2x1"

Connect t he cont roller's input cord wit h out put supply of t ransformer.
There are two ways on each set of controller, each way includes four light units. You need to figure out lay out of your hardscape project first, then place the controller in the right place. Warning: There is a blue tooth module inside controller box, which connects with smart hub to realize remote or voice control. Please don't cover controller box with metal box or put it in case made of metal or cement. Place t he st ainless st eel mount ing bracket bet ween layers of hardscape mat erial.
Drill 6* 1'' expansion pipe into wall, use screw driver to fix st4.2* 1'' hook into expansion pipe, use hook to hang
up cable before or after connector port and lock the wire. Adjust cable length of each light unit, connect male connector with female connector of controller,and use screw ring to fasten them. Repeat this step to connect all light unit with controller. Warning: Please make sure the edge of input wire of light unit is accessible in case that you need to replace or remove light unit later.
Connect transformer to main power supply.
7) Refer to User M anual and Voice Guideline to set up products.

ORBH

4

INPUT 120V

Low Voltage Bluetooth Controller
OUTPUT 12V

18

180

39.37

4

3-Year Limited Warranty
for up to 3-years. Based upon reasonable household usage,when used in accordance with package and smart@cloudybaylighting.com

FCC Caution: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received , including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. To maintain compliance with FCC s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna. FCC ID: 2A4FVCBSHL125BLORBH


Adobe Illustrator CS6 (Windows) PDFsharp 1.50.5147 (www sharp.com) (Original: iLovePDF)