User Manual for GOBOOST models including: 18P.5.LLCPA.1 Mobile Signal Repeater, 18P.5.LLCPA.1, Mobile Signal Repeater, Signal Repeater, Repeater

18P英文

蟲蟲さま

Specification Sheet (PDF)

Cell Phone Signal Booster for Home, Band 2/4/5/12/13/17/25/66 Cell Phone Booster Up to 5,000 sq.ft, 3G 4G LTE 5G Cell Booster for All U.S. Carriers - Verizon, AT&T, T-Mobile | FCC Approved : Cell Phones & Accessories

PDF preview unavailable. Download the PDF instead.

B1NiE88jwoL
<<<UserManual
Mobilesignalrepeater

Productparameters

Productdisplay

model 18P.5.LLCPA.1
Network LTE-B12LTE-B13CDMAPCSAWS
parameter

Frequency Range
Output Power Gain

Frequency LTE-B12 LTE-B13 CDMA
PCS AWS

Uplink 699~716 777~787 824~849 1850~1910 1710~1755 16±2 dBm 58±3 dB

Downlink 729~746 746~756 869~894 1930~1990 2110~2155 16±2 dBm 63±3 dB

FREQUENCY LIGHT

Bandwidth Ripple in Band
Spurious Emission
Intermodulation Products VSWR MTBF Power Supply Power Comsumption Impedance

17M+10M+25M+60M+45M

LTEB12/176dB;LTE-B136dB;CDMA6dB;PCS 6dB;AWS6dB

9KHz~1GHz 1GHz~12.75GHz
9KHz~1GHz 1GHz~12.75GHz

 -36 dBm  -30 dBm  -36 dBm  -30 dBm 3 50000 hours AC100~240V, 50/ 60HzDC5V 3A < 6W 50 ohm

Outputgain

Mechanical Specification
RF Connector Dimensions (D*W*H ) Packing size (D*W*H ) Net weight Gross weight Installation Type Environment Conditions Humidity Operating Temperature

N-Female N 253*160*28mm 335*220*50mm <0.53KG <0.87KG Wall Installation IP40 < 90% -10 ~ 55

POWERLIGHT
PowerSupply Indoorport

Installationsteps

installationdrawing

Step1:Installtheoutdoor antennaontherooforother positionswhereyoucanreceive 4barsofsignalormore

Step2:Connecttheoutdoor antennatotheBTSportviathe cableandtightenthe connectorsatbothends,make theoutdoorantennapointto thebasestation

basestation

Step3:Connecttheindoor antennatotheMSport,and placetheindoorantennaata higherpositionsoasto increasesignalcoverage

outdoorantenna host
Indoorantenna

Step4:Afterconnectingand tighteningthetwoantennas, pluginthepowersupplyand checktheconditionofthe signaldisplaylight
Step5:Checkwhetherthe phonesignalhasbeen improvedornot.Ifitisnotideal, youcanadjusttheheightor directionoftheoutdoor antenna.Agoodoutdoorsignal ishalfofthesuccess.

ApplicationScenario

villa

basement

residence

frequentlyaskedquestion

FAQ

Solutions

After the installation, the signal improvement is not significant, and the indoor coverage area is small

1. Adjust the position and direction of the outdoor antenna 2. Check if the cable is properly connected 3. Raise the outdoor antenna so that it can receive better signals
4. Replace high-power amplifier 5. Replace a high gain outdoor antenna

The phone signal is full, but the call quality is poor

The distance between outdoor and indoor antennas are too close, so it is necessary to increase the distance between them, or increase barrier isolation between them

After installation, the signal did not improve, but it was worse

The distance between outdoor and indoor antennas are too close, so it is necessary to increase the distance between them, or increase barrier isolation between them

I have been using it normally before, but suddenly the signal is not good after using it for a period of time

1. Check if water ingress at outdoor cable joints
2. Check if the power indicator light is normal 3. If there is no water ingress into the cable and the power indicator light is normal, it is possible that the amplifier has malfunctioned and needs to be returned to the factory for repair

Attention:Theremustbeasolid wallbetweentheindoor antennaandtheoutdoor antennatopreventselfoscillation.

hotel

Officebuilding

BarKTV


Corel PDF Engine Version 18.1.0.661 CorelDRAW X8