Mounting Instruction

Safety Instructions

⚠ WARNING

ELECTRIC SHOCK OR FALLING

Avoid mounting the antenna near power lines.

When installing an antenna from a ladder or elevating equipment, take precautions to avoid falling and ensure the equipment is securely positioned on solid ground.

Failure to follow these instructions can result in death, serious injury, or equipment damage.

General Instructions

• If exposed to extreme environmental conditions, especially icy conditions or a polluted atmosphere, the connectors should be covered with a self-vulcanizing tape or a cold shrink tube.
• If you mount the antenna on a false ceiling make sure that it is made from material with low electromagnetic loss, for example mineral fiber.
• Secure the antenna in a proper manner to ensure that the antenna stays in a stable position during its whole life cycle.

Disclaimer

All pertinent country, state, regional, and local safety regulations must be observed when installing and using this product. For reasons of safety and to help ensure compliance with documented system data, only the manufacturer should perform repairs to components. This equipment must only be installed and serviced by qualified personnel.

Measuring Units

The dimensions are in mm.

The tightening torques are in lb in and Nm.

Mounting Options

Mounting on the ceiling without brackets

Diagram Description (Figure 1): Shows the antenna being mounted on a ceiling without brackets. Key dimensions indicated are a hole spacing range of Ø21-35 mm and individual hole diameters of Ø6 mm.

Mounting on the ceiling using brackets

• Mount the brackets on the ceiling.
• Mount the antenna on the brackets.

Note: Use a tightening torque of 106.2 lb in / 12 Nm.

Reverse mounting on the ceiling using brackets

• Mount the brackets on the ceiling.
• Mount the antenna on the brackets.

Note: Use a tightening torque of 106.2 lb in / 12 Nm.

Diagram Description (Figure 2): Illustrates the mounting process using brackets, with overall dimensions of 326 mm, hole diameters of Ø6 mm, and a radius of R 28 mm.

Diagram Description (Figure 3): Depicts the reverse mounting configuration using brackets.

Drilling Template

On the next page, a drilling template is provided on a scale of 1:1.

Diagram Description (Page 4): A drilling template showing hole placement. Key dimensions include a total length of 140 mm, spacing of 25 mm, central hole diameter of Ø25 mm, and spacing of 10 mm.