Beko PRDF34552SS Dual Fuel Range Wiring Schematics

Safety Precautions

⚠️ Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

⚠️ WARNING: POWER MUST BE DISCONNECTED BEFORE SERVICING THE APPLIANCE

LED Indicator Lighting Schematic

This schematic illustrates the wiring for the LED indicator lighting system. It details the connections from various knob lighting points to the main electronic control board.

Key Connections:

• Knob Lighting Points: REAR LEFT, FRONT LEFT, CENTER, FUNCTION, TEMPERATURE, FRONT RIGHT, REAR RIGHT.
• Electronic Control Board: The central unit receiving signals from the knob lighting.
• Connection Labels: Various points are labeled with connection identifiers such as KN1, KN4, KN5, KN6, KN7, KN8, KN9, KN10, KN12, and KN13.

Main Appliance Wiring Schematic

This section provides a comprehensive wiring diagram for the Beko PRDF34552SS Dual Fuel Range, detailing the interconnection of major electrical components.

Major Components and Interconnections:

• Electronic Control Board: The primary control unit for the appliance.
• Terminal Block:
  • Power Input: L1 (BLACK wire), L2 (RED wire), N (WHITE wire).
  • Ground: EARTH (GREEN wire).
• Heating Elements:
  • UPPER OUTER: 2000 W
  • UPPER INNER: 1500 W
  • BOTTOM: 2400 W
• Motors:
  • CONVECTION MTR.FAN 1 (⚙️)
  • CONVECTION MTR.FAN 2 (⚙️)
  • LATCH MOTOR (⚙️)
• Other Components:
  • COOLING FAN (?️)
  • OVEN LAMP (?)
  • BUZZER (?)
  • RE-IGNITER
  • CUT-OFF VALVE (⚙️)
• Sensors and Switches:
  • TEMP. SENSOR OVEN (?️)
  • FUNCTION SELECTOR
  • TEMP. SELECTOR
  • OVEN LAMP SWITCH
  • Various Switches (SW1, SW2, SW3, SW4, SW5) associated with specific appliance functions or zones (e.g., REAR LEFT, FRONT LEFT, CENTER, FRONT RIGHT, REAR RIGHT).
• Protection and Control Modules:
  • THERMAL CUT-OUT (110°C)
  • EMC FILTER

The diagram shows extensive wiring, indicated by connection labels (e.g., KN201, KN202, KN203, KN204, KN205, KN207, KN208, KN209, KN211, KN212, KN213, KN214, KN215, KN216, KN217, KN218, KN219, KN220, KN222, KN223, KN225, KN226, KN227, KN228, KN229, KN230, KN231, KN232, KN233, KN234, KN235, KN236, KN237, KN238, KN239, KN240, KN241, KN242, KN243, KN100, KN101) connecting these components to the electronic control board and terminal block. Relays (e.g., RL201, RL202, RL203, RL207, RL208, RL209, RL210, RL212, RL214, RL215, RL217, RL218, RL219, RL220) are used for switching various circuits.

The diagram also includes labels for specific switches like SW1 and SW2 associated with the CUT-OFF VALVE and LATCH MOTOR, and SW1-SW5 for other functions.