Remock Code Biometric Keypad

by Gescasi

Product Overview

The Remock Code is a wireless panel featuring a fingerprint reader, a 125 KHz proximity card reader, and a touch keypad. It is fully compatible with Remock and Remock Pro invisible locks, and the Remock Magic motorized cylinder. Installation can be done using either hardware or 3M double-sided adhesive. The device utilizes a rolling code encryption algorithm and a split design for enhanced security. It can store up to 1000 fingerprint/PIN/user card combinations. Due to its low power consumption, batteries typically last approximately six months with an average of 30 operations per day, and the device will intelligently warn when batteries are low.

Common Features

1000 fingerprint/PIN/Card users
4-6 digit PIN, 125 KHz EM Card
433 MHz Rolling Code technology
Communication distance: 30 m (Maximum)
Ultra low power consumption
Requires 3 AAA batteries

Installation

Method 1: Double-sided 3M adhesive

The kit includes a 3M double-sided adhesive for easy mounting on a smooth surface. Optimal adhesion is achieved after 24 hours.

Method 2: Screws

Remove the rear cover.
Drill two holes (A, C) in the wall for wall plugs and one hole (B) for the cable.
Pass the cable through the wall hole and fix the cover to the wall using the two screws.
Secure the reader to its cover with the screw located on the bottom side.

Diagram showing screw hole placements (A, B, C) and dimensions for the Remock Code device.

Simplified Programming

Function Description	Operation
Enter programming mode	*(123456) # (Default MASTER code)
Change MASTER Code	0 (New Code) # (Repeat New Code) # (Code: 6 digits)
Add fingerprint user	1 (User ID) # (Put Fingerprint 3 times) #
Add user PIN	1 (User ID) # (PIN) # or 1 (PIN) # (PIN length: 4-6 digits)
Add user Card	1 (Zoom in Card) #
Delete user	2 (Fingerprint) # or 2 (User ID) # or 2 (PIN) # or 2 (Card) #
Exit programming mode	*
How to open the door
Fingerprint access	(Place Fingerprint)
PIN access	(PIN) #
Card Access	# (Zoom in Card)
Close immediately	Press "0 #" on the device

Programming with Invisible Lock

Enter programming mode: Remove the battery cover of the invisible lock (Remock or Remock Pro). Press the registration button (round black button left of batteries) with a thin rod and hold for 3 seconds until three beeps are heard, indicating the lock has entered programming mode.
Remock Code wireless panel programming: Press the "0" button and release. Then press and hold the "#" button for 2 seconds. A beep from the lock indicates successful programming of the wireless panel with the lock.
Exit programming mode: Press the registration button on the invisible lock again until a beep is heard, or wait for the automatic 15-second timeout. A beep will signal the end of programming.

Programming with Smart Lock

Insert new controller from Remock MAGIC motorized cylinder: Navigate to the configuration menu via the app's menu button. Select 'Users' (third icon from the left), then 'Enroll new controller'. Tap the green '+' button. A long warning tone (5 seconds) followed by a short tone will sound. Proceed immediately to the next step.

Diagrams illustrating the app interface for enrolling a new controller.

Remock CODE wireless panel programming: Press the "0" button and release. Then press and hold the "#" button for 2 seconds. If successful, two tones will be heard from the cylinder, and the wireless panel will be recognized as a new controller.